5 First installation
Your receiver is connected to the satellite antenna,TV set and other equipment according to the diagrams in paragraph 4.1.
-Switch on your TV set and select a channel.
-Plug your receiver into the mains.The welcome screen appears.
-Wait for a few seconds for the First installation screen to appear.
Note: if no picture appears, press the <TV/STB> button twice.
5.1Installation settings
-Select your favourite language.
-Select your country.
-Select your TV screen format.
To install ASTRA 19.2° East satellite only:
-Check for adequate signal strength and quality.
-If necessary, change the pointing of your antenna so as to maximize the level of the signal quality and strength bargraph indicators, then fasten your antenna according to the antenna user manual instructions.
-Press <OK> to start searching for channels broadcast on the ASTRA 19.2° East satellite.The Installation screen appears.
-Proceed to paragraph 5.2.
To install ASTRA 19.2° East and other satellites:
-Press <EXIT> to access the Antenna Configuration screen.
-Select antenna settings as described in paragraph 11.6.1.
-Proceed to paragraph 5.2.
5.2Channel search/Time setting
5.2.1Channel search
During the search process, the following information is reported on screen:
•the number of TV and Radio channels detected,
•the scanning progress, indicated as a percentage,
•the strength of the signal and the quality of reception.
English