English
•Channels lists: select RESET to replace all channel lists, VIRGIN to reset the receiver to the factory settings by pressing the red colour key, and then launch first installation, or NO CHANGE to keep your channel lists as they are.
Note: in the latter case, you will need to use the Channel Manager feature to add channels to your lists from the updated channel pool.
-Press <EXIT> to go back to the Antenna Configuration screen.
11.6.4 Search for new channels
-Check for adequate signal strength and quality for each LNB/satellite.
Note: to display the signal strength and quality for a particular satellite, scroll to the corresponding LNB.
-If necessary, change the pointing of your antenna(s) so as to maximize the level of the signal quality and strength bargraph indicators, then fasten your antenna(s) according to the antenna user manual instructions.
Note: to enable the audible signal quality indicator, press the yellow colour key.
-Press <OK> to start searching for channels.The Installation screen appears.
During the scanning process, the following information is reported on screen:
o the number of TV and Radio channels found,
o the scanning progress, indicated as a percentage,
o the strength of the signal and the quality of reception.
Note: if you press <EXIT> during the scanning process, you interrupt the scanning and return to the Antenna Configuration screen. In this case, none of the channels found are stored.
When scanning has been successfully completed, a completion message is displayed as well as the number of channels detected.
-Press <OK> to tune the receiver to the first channel in the main channel list.