English
Note: if you press <EXIT> during the scanning process, you interrupt the scanning and go back to the previous screen. In this case, none of the channels found are stored.
Once scanning has been successfully completed, a completion message is displayed.
-Press <OK>; a new screen appears, with a message indicating that a search for new software is in progress.
-Press <EXIT> to stop searching and tune the receiver to the first channel in the main TV list.
-Alternatively, wait for software detection, and then proceed as described in paragraph 11.5.4.2.
5.2.2Setting the correct time for summer or winter season
Summer and Winter time changes require the manual setting of the “Time Offset”. Refer to chapter 11.5.3 of the user manual to set the “Time Offset” menu option to the appropriate value:
-For summer season it should be set to GMT+2
-For winter season it should be set to GMT+1
5.3Search failure
In case of channel search failure, a message is displayed.
-Press <EXIT> to go back to either the First Installation or Antenna Configuration screen.
Before starting a new scanning
The following checks are recommended to recover adequate signal quality and strength:
•Check the antenna cable.
•Then check the antenna connection to your receiver (see chapter 4).
•Then change the pointing of your antenna so as to maximize the level of the signal quality and strength bargraph indicators, and then fasten your antenna according to the antenna user manual instructions.
-When the signal strength and quality is adequate, press <OK> to launch a new search.
If the failure message appears again, refer to the Troubleshooting chapter to find out the reason for failure. For a proper diagnosis and installation check, call your installer.