English
1 Product description
1.1Unpacking
Unpack the receiver and check to make sure that all of the following items are also included in the package:
-1 remote control with 2 batteries (LR6 AA 1,5 V),
-1 SCART cable,
-1 mains cord,
-1 user manual,
-1 Worldwide Warranty booklet.
Plastic bags can be dangerous.To avoid suffocation keep the bag away from babies and children.
1.2Installing the receiver in the upright position (DSR 2010 only)
Your receiver can be integrated in different ways within your existing
The receiver can be used in the horizontal or vertical position. If you decide to use your receiver in the upright position, follow the instructions below:
-Unpack the stand, place it on a horizontal surface with the click fit side on the left and lug side on the right.
-Position the receiver as shown below (rear panel on the left side and coaxial connectors on the
bottom side).
- Insert the stand lug in the slot located on the front of the receiver, close to the Philips badge.
-Rock the receiver to insert the stand lug fully in the slot until it is locked by the click fit. Then your receiver can be used in the upright position.
Note: to remove the stand, unlock the click fit at the rear side of the stand, rocking and pulling back the receiver to extract it from the stand lug.