Cisco Systems PIX515E quick start Ethernet

Ethernet 5

Ethernet 3

	DO NOT INSTALL INTERFACE
	CARDS WITH POWER APPLIED
	100 Mbps Link		FDX 100 Mbps Link			PIX-515
					FDX	FAILOVER
	10/100	ETHERNET 0/0		10/100	ETHERNET 0/0
						CONSOLE
Ethernet 2
Ethernet 4	Ethernet 1
			Ethernet 0
Ethernet 2
	DO NOT INSTALL INTERFACE
	CARDS WITH POWER APPLIED
	100 Mbps Link		FDX 100 Mbps Link			PIX-515
					FDX	FAILOVER
	10/100	ETHERNET 0/0		10/100	ETHERNET 0/0
						CONSOLE
Ethernet 3	Ethernet 1

Ethernet 0

99544

99545

•If your PIX 515E has one or two single-port Ethernet circuit boards installed in the auxiliary assembly on the left of the unit at the rear, the circuit boards are numbered top to bottom so that the top circuit board is Ethernet 2 and the bottom circuit board is Ethernet 3. (Using more than one Ethernet circuit board requires the

PIX 515E-unrestricted license for access. If a four-port FE card is used with the restricted license, only one network interface is activated.)

Note If you need to install an optional circuit board, refer to the “Installing a Circuit Board in the PIX 515E” section in the Cisco PIX Firewall Hardware Installation Guide.

If you have a second PIX 515E to use as a failover unit, install the failover feature and cable as described in the “Installing Failover” section in the Cisco PIX Firewall Hardware Installation Guide.

33