Step 3 Connect the inside, outside, or perimeter network cables to the interface ports. Starting from the top left, the connectors are Ethernet 2, Ethernet 3, Ethernet 4, and Ethernet 5. The maximum number of allowed interfaces is six with an unrestricted license.
Note Do not add a
Step 4 Power on the unit from the switch at the rear to start the PIX 515E. Do not power on the failover units until the active unit is configured.
Check the LEDs
POWER ACT NETWORK 97779
Table 1 | PIX 515E Front Panel LEDs | |||
|
|
|
|
|
LED |
| Color | State | Description |
|
|
|
|
|
POWER |
| Green | On | On when the unit has power. |
|
|
|
|
|
ACT |
| Green | On | On when the unit is the active failover unit. If failover is present, |
|
|
|
| the light is on when the unit is the active unit. |
|
|
|
|
|
|
|
| Off | Off when the unit is in standby mode. If failover is not enabled, this |
|
|
|
| light is off. |
|
|
|
| |
NETWORK | Green | Flashing | On when at least one network interface is passing traffic. | |
|
|
|
|
|
34