Dell 740N, 720N, 760N manual Scsi Host Adapter 0b

Page 64

*Env-B rupt err *Env-C rupt err *FP button stuck *FLPY init fail *FLPY reg error

￿￿￿￿￿7￿￿￿￿#￿￿

If the hardware passes all POST tests, the filer begins to load the filer software and display informational boot messages.

Figure 3-7 shows a sample message that appears on the system console when the filer is successfully started. The exact boot messages that appear on your system console depend on your system configuration.

If you are starting the system from a system boot diskette, some messages might be different from the following messages. Refer to the Dell PowerVault 720N, 740N, and 760N System Administrator and Command Reference Guide for information about how the filer is started from a system boot diskette.

NetApp Release 5.3: Fri Apr

23 14:57: 51 CDST 1999

System ID: 0016788685 ()

 

slot 0: System Board

 

Memory Size:

512 MB

slot 0: Fibre Channel adapter

Version 1.12

 

Host Loop Id 119

 

Cacheline size 8

FC Packet size 2048

3 Disks:

25.8GB

1 shelf with DISK ENCLOSURE

SCSI Host Adapter 0b

 

slot 0: Ethernet Controller

e0

MAC Address: 00:a0:98:00:3b:71 (auto-100tx-fd-

up)

 

slot 3: Ethernet Controller

e3

MAC Address:

00:a0:92:f7:62:56 (tp-down)

slot 9: NVRAM

 

Memory Size:

32 MB

Please enter the new hostname [ ]:

 

 

￿￿￿￿￿￿￿￿￿.￿￿￿￿￿￿￿￿:￿￿￿￿￿￿￿

 

3-12 Dell PowerVault 720N, 740N, and 760N Installation and Troubleshooting Guide

Image 64
Contents Page Page Observe the following warnings while servicing this system 006 Vii Viii #$% #-%% #+%$ Page Xiii Xiv Monospaced font Xvi Xvii Xviii Xix Page Xxi Xxii $%$%*$+ Activity LED Status LED Power LED Nostic messages up to 32 characters Describes the back panel features 10/100Base-T Ethernet Disk-Array Enclosure DAE storage system with 18-GB #$!% Slot 9 dedicated to Nvram card $%&# $&#Introduction Page Installing a Filer System +,+ 145=1.75 inch DAA1% 24769!8 Shows the rack adapter rails properly positioned in the rack +6939 Page Installing a Filer System Select any two holes +-0%$ #,,#6233#./$&&# FC-AL1 loop FC-AL0 loop FC-AL adapter in slot $&$2 77% Installing a Filer System #,+ $!1Built-in Ethernet connector 33!# 13 shows the location of the Console port 14 shows two power supplies $&&#AC LED Page 122# Shows the LEDs on the front panel +$ 1# Off-AC signal is not good #1&21 41&21 Quad-port Ethernet card #=# Troubleshooting the Filer Hardware 37# Startup failed Scsi Host Adapter 0b Administrator and Command Reference Storage enclosure address number. Setup Page Filer’s /etc/passwd and /etc/group Mode. Refer to the Dell PowerVault 720N This message appears in these situations Guide System Administrator and Command Ref Page Getting Help Ftp.dell.com Sales@dell.com Support@us.dell.comInfo@dell.com Page Getting Help Diagnostics Checklist 1344 Page Austria AustraliaBelgium Brunei CanadaChile ChinaFinland DenmarkFrance Germany Hong KongIreland ItalyKorea JapanLatin America Luxembourg MacauMalaysia MexicoNetherlands New ZealandNorway PolandSingapore South AfricaSoutheast Asian Pacific CountriesSweden SwitzerlandTaiwan ThailandDell Home and Small Business Group Index Message FC-AL See also Dimms Index Nics Scsi
Related manuals
Manual 128 pages 1.69 Kb