See also Dimms

halt command, 2-14,3-21

Halted message, 3-21

height of filer, 2-3

help tools

AutoTech service, 4-3 Internet, 4-2 TechConnect BBS, 4-3 TechFax service, 4-3

humidity, environmental requirements, 2-2

informational messages

see error and informational messages

installation brackets, 1-2

installing the filer, 2-1,2-8connecting to a disk storage shelf, 2-11connecting to a power source, 2-20connecting to a tape backup device,

2-14

connecting to the network, 2-15 establishing a terminal connection,

2-18

in a rack, 2-4

preparing for the installation, 2-1

Internet help tools, 4-2

Invalid PCI card slot n message, 3-14

ISA IOCHK message, 3-21

Light Emitting Diodes (LEDs), 1-2,3-210/100Base-T Ethernet cards, 3-5,3-6activity LED on the front panel, 3-3built-in Ethernet interface, 3-5

front panel, 3-2,3-3

power LED on the front panel, 3-3 power supply, 3-3

quad-port 10/100Base-T Ethernet card, 3-6

status LED on the front panel, 3-3

Liquid Crystal Display (LCD), 1-3

Liquid Crystal Display (LCD) messages, 3-9

Data disk n x% rebuilt, 3-17Disk hung during swap!, 3-21 Disk labels scramble!, 3-13 Disk n is broken, 3-17

Fault on shelf n, 3-18Maintenance mode, 3-18NFS service not enabled, 3-18

No FC-AL or SCSI disk controllers!, 3-15

Non Maskable interrupt, 3-18Parity disk is broken, 3-18,3-19Parity disk x% rebuilt, 3-19POST error messages, 3-11Power supply degraded!, 3-19Replace NVRAM batteries!, 3-19Reporting SNMP traps, 3-20Setting time from remote host, 3-20 Setting up SNMP trap host, 3-20 STDBY/SERV, 3-3

Unsupported NVRAM size xMB, 3-16

xdefault route, 3-20

xroute to y, 3-20

	2	#

	L2 parity error message, 3-11	Maintenance mode message, 3-18

	LCD	maximum current, for the filer, 2-2
	see Liquid Crystal Display
		memory
	LEDs
		See also DIMMS
	see Light Emitting Diodes

4 Dell PowerVault 720N, 740N, and 760N Installation and Troubleshooting Guide