Dell 740N, 720N, 760N manual shows the location of the Console port

Page 49

0￿.￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

To connect an ASCII terminal to the filer, perform the following steps:

1.Ensure that the terminal settings match the filer’s, listed in Table 2-8.

￿￿￿￿￿￿￿￿0￿￿￿ ￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿--￿￿￿￿￿￿￿￿￿￿￿ ￿￿￿￿￿￿￿

1￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

 

 

Line speed

9600 baud

Data bits per character

8

Parity

None

Stop Bits

1

Flow Control

None

 

 

Refer to the documentation for your terminal for further details.

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿+￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

2.Connect the cable’s socket end to the filer’s plug connector, labeled CONSOLE.

Use the provided DB-9–to–DB-9 serial cable.

Figure 2-13 shows the location of the CONSOLE port.

Console port

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿'￿￿￿￿￿￿￿

￿ ￿￿￿￿￿￿￿￿￿￿￿￿￿#￿￿￿￿￿￿￿￿,￿￿￿￿￿￿￿￿￿￿

If you are connecting an ASCII terminal from a remote site, be sure that you do not have a local terminal connected to the filer’s CONSOLE port.

Installing a Filer System 2-19

Image 49
Contents Page Page Observe the following warnings while servicing this system 006 Vii Viii #$% #-%% #+%$ Page Xiii Xiv Monospaced font Xvi Xvii Xviii Xix Page Xxi Xxii $%$%*$+ Activity LED Status LED Power LED Nostic messages up to 32 characters Describes the back panel features 10/100Base-T Ethernet Disk-Array Enclosure DAE storage system with 18-GB #$!% Slot 9 dedicated to Nvram card $&# $%&#Introduction Page Installing a Filer System 145 +,+=1.75 inch DAA1% 24769!8 Shows the rack adapter rails properly positioned in the rack +6939 Page Installing a Filer System Select any two holes #,,#6233 +-0%$#./$&&# FC-AL1 loop FC-AL0 loop FC-AL adapter in slot $&$2 77% Installing a Filer System $!1 #,+Built-in Ethernet connector 33!# 13 shows the location of the Console port $&&# 14 shows two power suppliesAC LED Page 122# Shows the LEDs on the front panel +$ 1# Off-AC signal is not good #1&21 41&21 Quad-port Ethernet card #=# Troubleshooting the Filer Hardware 37# Startup failed Scsi Host Adapter 0b Administrator and Command Reference Storage enclosure address number. Setup Page Filer’s /etc/passwd and /etc/group Mode. Refer to the Dell PowerVault 720N This message appears in these situations Guide System Administrator and Command Ref Page Getting Help Ftp.dell.com Sales@dell.com Support@us.dell.comInfo@dell.com Page Getting Help Diagnostics Checklist 1344 Page Austria AustraliaBelgium Canada BruneiChile ChinaFinland DenmarkFrance Hong Kong GermanyIreland ItalyKorea JapanLatin America Macau LuxembourgMalaysia MexicoNew Zealand NetherlandsNorway PolandSouth Africa SingaporeSoutheast Asian Pacific CountriesSwitzerland SwedenTaiwan ThailandDell Home and Small Business Group Index Message FC-AL See also Dimms Index Nics Scsi
Related manuals
Manual 128 pages 1.69 Kb