Teledyne API Model T201 NH3 Analyzer Operator Manual | T201 Ammonia Analyzer |
1.4T201 ANALYZER SPECIFICATIONS
Table 1-1. T201 Operating Specifications
Ranges
Measurement Units
Noise at Zero1
Noise at Span1
Lower Detectable Limit2
Zero Drift3, 6
Span Drift6
Lag Time
Rise Time4
Fall Time4
Sample Flow Rate
Linearity
Temp Range
Dimensions H x W x D
Weight, Analyzer
Weight, Converter
Weight, Pump
Power, Analyzer
Power, Analyzer5
Power, Pump
Power, Pump CE Mark5
Environmental
Analog Output Resolution
standard
Serial I/O
optional
Min:
Max:
PPB, PPM, microgram/m3, milligram/m3 (user selectable)
<0.5 ppb RMS
<1.0% of reading above 50 ppb
1 ppb RMS
2 ppb / 24 hours
<1.0% FS Range / 24 hours
40 seconds
90% 300 seconds
90% 300 seconds
1000 cm3/min + 10% (500 cm3/min bypass to vacuum manifold, 500 cm3/min to reaction cell)
NO calibration 1% of full scale NH3 calibration 2% of full scale
7” x 17” x 23.6” (18cm x 43cm x 61cm)
43 lbs (20 kg)
24 lbs (11 kg)
16 lbs (7 kg)
100V ~50/60 Hz, 120V ~60 Hz, 220V ~50Hz, 240V ~50 Hz, 125 watts 230V ~50 Hz, 125 watts
110V ~60 Hz, 220V ~50 Hz, 240V ~50 Hz, 295 watts 230 V ~50 Hz, 2.5 A peak
Installation Category Pollution Degree 2,
(1)Ethernet:
(2)USB device ports; (8)
(1)USB com port; (1) RS485 (300 – 115,200 baud); (8) analog inputs
1As defined by USEPA
2Defined as twice the zero noise level
3At constant temperature and voltage
4When pneumatics are conditioned with NH3 overnight and the gases (zero air to NH3) are manually switched at the sample inlet at the rear of the M501.
5Electrical rating for CE Mark Compliance
6Applies when sampling NH3; better results expected for NO/NOx gas measurements.
07271B DCN6646 | 13 |