Wheel removal | Fitting this cap is particularly important when you are using the |
| XC skiing kit. |
TIP
When removing the wheels, the parking brake must be off. Ensure too that all brake cables with their end caps are pro- perly located in the relevant hole of the adjusting screws. If necessary do the same for the adjusting screw on the brake lever (the one that you are not to adjust).
To remove the wheel press the unlocking button in the centre of the wheel and pull the wheel off to the side.
The brake mechanism that is now exposed is sensitive to dirt.
To protect it from dirt, Chariot supplies two protective caps. We recommend that each time the wheels are removed these caps be inserted on the brake callipers.
Wheel fitting
TIP
When fi tting the wheels, the parking brake must be off. Ensu- re too that all brake cables with their end caps are properly located in the relevant hole of the adjusting screws. If neces- sary do the same for the adjusting screw on the brake lever (the one that you are not to adjust).
To fi t the wheel, press the unlocking button in the centre of the wheel and push the axle into the wheel mount socket until it can go no further. Release the unlocking button. The axle will now click in.
DANGER
Make sure that you check that both wheels are properly seated by pulling the wheel hard to one side without pres- sing the unlocking button. To do this lift the carrier slightly and hold it fi rm with one hand. Check a number of times that the wheel cannot be pulled off, and give it a good shake as well to make sure.
22