Chariot Carriers CX 2, CX 1 manual Fitting the ski arms to the carrier, Identical for all models

Page 45

Pressing down the locking button on the axle, insert the XC Skiing Kit into the axle socket on the Chariot CX until it can go no further. Release the locking button. The axle will now click if installed fully.

Make sure the skis are inserted correctly with the ski tips towards the front of the carrier.

Now secure the arms by inserting the security pin from above through the vertical hole in the arm and VersaWing 2.0 until it stops. Lock the security pin by looping the spring clip over the pins end that protrudes underneath the VersaWing 2.0.

DANGER

Always check that both ski frames are properly attached by pulling the ski frame outwards hard without pressing the axle’s locking button. To do this, lift the carrier slightly and hold it fi rm with one hand. Make sure that the ski cannot be pulled off, by giving it a few good shakes.

DANGER

Always make sure that the security pins of the ski arms are properly inserted to prevent the carrier from accidentally sliding away. You run the risk of an accident!

Fitting the ski arms to the carrier

Identical for all models.

Insert each arm into the VersaWing 2.0 until the vertical holes in the arms and VersaWing 2.0 are aligned with each other. The arms should now, at the back in the slot of the VersaWing 2.0, protrude about 2 cm / 3/4“ over the plastic edge.

TIP

The holes in the ski arms are larger than the security pins, so that the arms can rotate slightly around their longitudinal axes (in order to adapt to narrow or wide hips, and single and double width carriers).

45

Image 45
Contents Cheetah 1, Cheetah 2, Cougar 1, Cougar 2, CX 1, CX Table of Contents General Items Congratulations on buying this child transporterIntended Use Explanation of symbols and instructions Overview of Components SafetySafety information for all travelling situations General safety instructionsSafety instructions for maintenance and repairs Safety instructions for carrying infantsDescription of the Ready Chassis Supplied as standardAssembling the Ready Chassis Assembly and folding upFolding up the Ready Chassis Wheel assemblyCougar and Cheetah Installing the handlebarSeat and Seatbelts Safety wrist strapHandlebar bag CX To fasten the child into the carrier, proceed as followsAdjusting the padded shoulder harness TIP Two-in-one weather cover Climate controlOpening the two-in-one weather cover SunscreenFront side air vent on the Cougar Side window on the CXStorage bags Larly to the upper mesh bag Adjusting the suspension Cougar and CXOperating the parking brake Cheetah and Cougar Safety Instructions Use as a wheel brakeUse as a parking brake Adjusting the brake system Case 1 Too much increase in brake lever play WrongrightStart by adjusting one of the wheels Case 2 Brakes pull unequally Basic adjustmentFine adjusting Carrier pulls to when the brake is appliedWheel fitting Wheel removalCleaning Care and maintenanceBrake cables Screw connectionsCycling Kit Safety instructions for use as a Bicycle TrailerChariot Cycling Kit Weber Cycling KitLegal requirements Performance characteristics when used as a Bicycle TrailerAssembling the reflectors and safety flag AssemblyFor the plastic wheels used on theCheetah Spoked wheels on the Cougar and the CXAttaching the hitcharm to CTS Ready Chassis Page Bicycle with solid axle Attaching the Axle-Mount ezHitchAttaching the carrier Special features of the VersaWing Fixing the Weber hitch to the bicycleFor this the carrier must not be folded Use Suitability of the bicycle used for towingTravelling Use as a pull wagon Safety instructions for use as a Jogging Stroller Jogging KitJogging Kit Performance characteristics when used as a Jogging Stroller Page Storing the wheels arms and 16 wheel Safety instructions for use as a Stroller Weight distributionStrolling Kit Strolling KitPerformance characteristics Travelling Hiking Kit Safety instructions for use as a Hiking CarrierTIP XC Skiing Kit Safety instructions for use as an XC Skiing CarrierCheetah und Cougar Assembly Attaching the skis to the carrierIdentical for all models Fitting the ski arms to the carrierPutting on the waist belt Length adjustment of the ski armsSafety instructions for use as Walker Walking KitFitting the drawbars to the carrier Length adjustment of the drawbars Service, Care and Storage AccessoriesSpecifications Warranty and GuaranteeMileage in km Type of ride