Chariot Carriers CX 2, CX 1 manual Attaching the hitcharm to CTS Ready Chassis

Page 27

Screw the red reﬂ ectors into the rear grommets on the storage bag.

Screw the white reﬂ ectors into the front grommets on the passenger compartment.

Push the two safety ﬂ ag rods together and guide the bottom end into the hole located in the plastic end cap in the upper left rear frame tube. Push the rod in until it stops.

Attaching the hitcharm to the

CTS Ready Chassis

The hitcharm is attached to the CTS Ready Chassis into the left “VersaWing 2.0” bracket.

The hitcharm must always be attached into the left-hand side of the carrier (as seen in the direction of travel). The hitcharm must always be attached with both spring buttons pointing upwards.

Press down the small button and slide the hitcharm into the VersaWing 2.0 until the large button engages in the VersaWing 2.0 (Figures 1 to 3).

27

Image 27

Contents Cheetah 1, Cheetah 2, Cougar 1, Cougar 2, CX 1, CX Table of Contents General Items Congratulations on buying this child transporterIntended Use Explanation of symbols and instructions Overview of Components SafetySafety information for all travelling situations General safety instructionsSupplied as standard Safety instructions for carrying infantsSafety instructions for maintenance and repairs Description of the Ready ChassisAssembling the Ready Chassis Assembly and folding upFolding up the Ready Chassis Wheel assemblyCougar and Cheetah Installing the handlebarTo fasten the child into the carrier, proceed as follows Safety wrist strapSeat and Seatbelts Handlebar bag CXAdjusting the padded shoulder harness TIP Sunscreen Climate controlTwo-in-one weather cover Opening the two-in-one weather coverFront side air vent on the Cougar Side window on the CXStorage bags Larly to the upper mesh bag Adjusting the suspension Cougar and CXOperating the parking brake Cheetah and Cougar Safety Instructions Use as a wheel brakeUse as a parking brake Adjusting the brake system Case 1 Too much increase in brake lever play WrongrightCarrier pulls to when the brake is applied Case 2 Brakes pull unequally Basic adjustmentStart by adjusting one of the wheels Fine adjustingWheel ﬁtting Wheel removalScrew connections Care and maintenanceCleaning Brake cablesWeber Cycling Kit Safety instructions for use as a Bicycle TrailerCycling Kit Chariot Cycling KitLegal requirements Performance characteristics when used as a Bicycle TrailerSpoked wheels on the Cougar and the CX AssemblyAssembling the reﬂectors and safety ﬂag For the plastic wheels used on theCheetahAttaching the hitcharm to CTS Ready Chassis Page Bicycle with solid axle Attaching the Axle-Mount ezHitchAttaching the carrier Special features of the VersaWing Fixing the Weber hitch to the bicycleFor this the carrier must not be folded Use Suitability of the bicycle used for towingTravelling Use as a pull wagon Safety instructions for use as a Jogging Stroller Jogging KitJogging Kit Performance characteristics when used as a Jogging Stroller Page Storing the wheels arms and 16 wheel Strolling Kit Weight distributionSafety instructions for use as a Stroller Strolling KitPerformance characteristics Travelling Hiking Kit Safety instructions for use as a Hiking CarrierTIP XC Skiing Kit Safety instructions for use as an XC Skiing CarrierCheetah und Cougar Assembly Attaching the skis to the carrierIdentical for all models Fitting the ski arms to the carrierPutting on the waist belt Length adjustment of the ski armsSafety instructions for use as Walker Walking KitFitting the drawbars to the carrier Length adjustment of the drawbars Service, Care and Storage AccessoriesType of ride Warranty and GuaranteeSpeciﬁcations Mileage in km