Chariot Carriers CX 2, CX 1 manual Performance characteristics, Assembly

Page 39

Safety instructions for using the brake system on the CX 1 and CX 2 models:

•Before using the brake system for the ﬁ rst time, acquaint yourself with its braking effect.

•On your ﬁ rst journeys always take the Owner’s Manual with you in case adjustments need to be made to the brake system.

•Check the braking effect before each journey.

•Before each journey check that both brakes operate with the same force.

•Before each journey check that the lock nuts are tight on the adjusting screws.

•Before each journey check that there are no kinks in or other damage to the brake cables.

•Always ensure that when the parking brake is applied the spring button is fully pressed in. If this is not done, the brake lever could be released and the parked carrier could roll away.

•Only park the carrier on ﬂ at surfaces.

•Check that the parking brake is working properly. Always check that the carrier cannot roll away. If the carrier is given a push, it should immediately come to a stop once it has been released.

•If the carrier is not held securely by the parking brake, the brake must be readjusted.

•Remember that the brake drums heat up when used, so there is a risk of burning yourself if you touch them.

•Before each journey make sure that the brake system adjusting screws are secured and not unscrewed too far.

•If you need to replace brake system components due to wear or for other reasons, only have replacement carried out by a Authorized Chariot Retailer.

•Keep the insides of the drum brake dry and free of dirt.

Performance characteristics

Inline skating with the Stroller is not permitted.

Assembly

To attach the stroller wheel, press the plastic button on the side of the VersaWing 2.0 until it can go no further. Then, from below, insert the upward pointing caster shaft of the stroller wheel into the vertical hole of the VersaWing 2.0 until it can go no further.

Release the plastic button. This now clicks back towards the outside, resulting in locking of the attachment axle of the stroller wheel.

DANGER

Always make sure that the stroller wheels are properly and fully engaged and locked. To check this pull the stroller wheels up and down in a vertical direction. Make sure that the plastic locking button has fully clicked back. Incorrect assembly may lead to accidents.

39

Image 39

Contents Cheetah 1, Cheetah 2, Cougar 1, Cougar 2, CX 1, CX Table of Contents General Items Congratulations on buying this child transporterIntended Use Explanation of symbols and instructions Overview of Components SafetySafety information for all travelling situations General safety instructionsSupplied as standard Safety instructions for carrying infantsSafety instructions for maintenance and repairs Description of the Ready ChassisAssembling the Ready Chassis Assembly and folding upFolding up the Ready Chassis Wheel assemblyCougar and Cheetah Installing the handlebarTo fasten the child into the carrier, proceed as follows Safety wrist strapSeat and Seatbelts Handlebar bag CXAdjusting the padded shoulder harness TIP Sunscreen Climate controlTwo-in-one weather cover Opening the two-in-one weather coverFront side air vent on the Cougar Side window on the CXStorage bags Larly to the upper mesh bag Adjusting the suspension Cougar and CXOperating the parking brake Cheetah and Cougar Safety Instructions Use as a wheel brakeUse as a parking brake Adjusting the brake system Case 1 Too much increase in brake lever play WrongrightCarrier pulls to when the brake is applied Case 2 Brakes pull unequally Basic adjustmentStart by adjusting one of the wheels Fine adjustingWheel ﬁtting Wheel removalScrew connections Care and maintenanceCleaning Brake cablesWeber Cycling Kit Safety instructions for use as a Bicycle TrailerCycling Kit Chariot Cycling KitLegal requirements Performance characteristics when used as a Bicycle TrailerSpoked wheels on the Cougar and the CX AssemblyAssembling the reﬂectors and safety ﬂag For the plastic wheels used on theCheetahAttaching the hitcharm to CTS Ready Chassis Page Bicycle with solid axle Attaching the Axle-Mount ezHitchAttaching the carrier Special features of the VersaWing Fixing the Weber hitch to the bicycleFor this the carrier must not be folded Use Suitability of the bicycle used for towingTravelling Use as a pull wagon Safety instructions for use as a Jogging Stroller Jogging KitJogging Kit Performance characteristics when used as a Jogging Stroller Page Storing the wheels arms and 16 wheel Strolling Kit Weight distributionSafety instructions for use as a Stroller Strolling KitPerformance characteristics Travelling Hiking Kit Safety instructions for use as a Hiking CarrierTIP XC Skiing Kit Safety instructions for use as an XC Skiing CarrierCheetah und Cougar Assembly Attaching the skis to the carrierIdentical for all models Fitting the ski arms to the carrierPutting on the waist belt Length adjustment of the ski armsSafety instructions for use as Walker Walking KitFitting the drawbars to the carrier Length adjustment of the drawbars Service, Care and Storage AccessoriesType of ride Warranty and GuaranteeSpeciﬁcations Mileage in km