8. The Hiking Kit | Assembly |
| Lay both the hiking arms with shoulder harness and waist strap |
| as shown in the “Supplied as standard” illustration in front of the |
| carrier. The waist strap must be attached to the insides of both |
| arms. |
| Insert each arms into the VersaWing 2.0 until the vertical holes |
| in the arms and VersaWing 2.0 are aligned with each other. |
| The arms should now protrude about 2 cm / 3/4 inch out of the |
| rear side of the VersaWing 2.0. |
|
|
Supplied as standard
Now secure the arms by inserting the security pin from above through the vertical hole in the arm and VersaWing 2.0 until it stops. Lock the security pin by looping the spring clip over the pins end that protrudes underneath the VersaWing 2.0.
2 hiking arms with shoulder harness and waist strap
Safety instructions for use as a Hiking Carrier
•Please make sure you read the safety instructions in the “Safety” section at the beginning of this Owner’s Manual.
•Before each journey check that all components are properly fi tted, particularly the wheels and the hiker arms.
•Always make sure that the security pin of the hiker arms is properly installed so as to prevent the carrier from accidentally separating from the arms.
•Be mindful of the space needed due to the width and length of the carrier. Take care in oncoming traffi c on narrow paths!
•Please remember that controlling a fully loaded hiker requires experience and good physical fi tness.
•Particular care is needed on slopes, uneven terrain and when stopping. Do not use on steep or diffi cult hiking trails.
•First take the hiker for a practice run without children, but with the maximum load. Perform the practice run on terrain that is more diffi cult to cover than that which you want to travel later with children.
DANGER
Always make sure that the security pin of the hiking arms are properly inserted to prevent the carrier from accidentally rolling away. You run the risk of an accident!
41