Combi 8100 instruction manual Remove the lower anchor connectors

19

2After selecting a seating location, if adjustable, adjust vehicle seat back into most upright position.

3Rotate car seat on lower base to rear-facing position, see “Changing Forward-Facing/Rear-Facing Use Position” section.

LATCH Connector

Storage Ring

Hook-on

Lower Anchor (fig. a) Connector

4 Remove the lower anchor connectors		Hook-on
from their storage locations on back		Connector
of car seat pad (fig. a).
- Depress spring on hook-on
connector (fig. b) and remove
from LATCH connector storage		Opening	(fig. b)
ring.
5 Lengthen lower anchor belt by		Pull
pressing down on belt adjuster		Belt Adjuster
slide button on top of belt	Lower	Slide Button
adjuster and pulling belt to
	Anchor Belt
extend the length of lower
anchor belt (fig. c).			Belt
		(fig. c)
			Adjuster

6Check that the lower anchor belt is through the belt path openings marked “Belt Here Rear-facing” (fig. d). If lower anchor belt is not through the rear-facing belt path openings, see “LATCH - Changing Belt Path Location” section.

7 Place car seat rear-facing in the vehicle seat location selected with rear-facing belt path toward vehicle seat back and centered between the vehicle lower anchors (fig. d).

8Recline car seat keeping the line inside level indicator in the green striped zone (fig. e). To change recline position, see “Recline Position Adjustment” section.

NOTE: Level indicator is located on the opposite side of car seat and not on the side shown.

(fig. d)

Rear-facing

Belt Path

Level

Indicator

(fig. e)

Green Striped Zone

20