Combi 8100 instruction manual Forward-facing Installation With Vehicle Seat Belt

Page 19

35

Storage Of Lower Anchor Belt And Connectors:

When not using the LATCH System, store the lower anchor belt and connectors by snapping the connectors onto LATCH connector storage rings located on the back side of the

seat pad (fig. l). Pull on free end of lower anchor belt to tighten.

NOTE: To prevent damage to the seat pad, care should be taken when removing or securing connectors. Excessive force could damage or tear seat pad.

(fig. l)

LATCH

Connector

Storage Ring

Section 9b - Forward-facing Installation

With Vehicle Seat Belt

WARNING

DEATH or SERIOUS INJURY can occur

Not all vehicle seat belts can be used with this car seat. Read vehicle owner’s manual and “Vehicle Seat Belts” section in this manual.

Vehicle seat belt MUST stay tightly adjusted around car seat at all times. If vehicle seat belt does not stay tight, read the vehicle owner’s manual and “Vehicle Seat Belts” section in this manual.

1Refer to vehicle owner’s manual to identify the seating locations which can be used with a car seat. Check for specific instructions for car seat use.

2After selecting a seating location, if adjustable, adjust vehicle seat back into most upright position.

3Rotate car seat on lower base to forward-facing position, see “Changing Forward-Facing/ Rear-Facing Use Position” section.

4Place car seat forward-facing in the vehicle seat location selected with forward-facing belt path openings toward vehicle seat back (fig. a).

36

(fig. a)

Forward-facing

Belt Path

Image 19
Contents Avatar Convertible Car Seat Table of Contents Proper Use Is Required Proper Use Check List Need help installing your infant car seat?Belt Path Avatar Car Seat PartsRear-facing Use 5 to 30 lbs .3 to 13.6 kg Use RecommendationsForward-facing Use 20 to 40 lbs to 18 kg Selecting a Vehicle Seating LocationTop Tether Information Options For Securing a Car SeatLatch System In Vehicles Latch SystemLatch System On This Car Seat Securing Car Seat To VehicleRear-facing Installation With Latch Rear-facing InstallationRear-facing For Use 5 to 30 Pounds 2.3 to 13.6 kg Remove the lower anchor connectors Fig. h Storage Of Lower Anchor Belt And Connectors Removal Of Car Seat Installed With LatchFig. a Rear-facing Belt Path Rear-facing Installation With Vehicle Seat BeltFig. e Removal Of Car Seat Installed With Vehicle Seat BeltForward-facing Installation With Latch Forward-facing InstallationForward-facing For Use 20 to 40 Pounds 9 to 18 kg Seat back and centered between Vehicle lower anchors fig. d Fig. g Pull to tighten Storage Of Lower Anchor Belt And Connectors Forward-facing Installation With Vehicle Seat BeltFig. b Fig. j Securing Child In Car Seat Click Harness Use and Adjustment Operation and AdjustmentsChanging Harness Positions To Re-secure Shoulder Harness Straps To change harness strap slotsInfant Insert Changing Crotch Strap PositionTo change use position Recline Position AdjustmentChanging Forward-Facing/Rear-Facing Use Position To change recline positionVehicle Seat Belts To provide a secure installation of the car seatLatch Changing Belt Path Location Flip Belts Forward of Seat BightLap or Shoulder Belt Mounted on Front Door fig. f Additional Information Care and CleaningRemoving Harness Covers, Seat Pad and Infant Insert Registration Information Cleaning Harness StrapsCleaning Shell Cleaning BuckleAvatar Convertible Car Seat