Combi 8100 instruction manual Seat back and centered between Vehicle lower anchors fig. d

31

2After selecting a seating location, if adjustable, adjust vehicle seat back into most upright position.

LATCH Connector

Storage Ring

3Rotate car seat on lower base to forward-facing position, see “Changing Forward-Facing/Rear-Facing Use Position” section.

(fig. a)

Hook-on Lower

Anchor Connector

4Remove the lower anchor connectors from their storage locations on back of car seat pad (fig. a).

-Depress spring on hook-on connector (fig. b) and remove from LATCH connector storage ring.

Hook-on

Connector

Opening (fig. b)

5Lengthen lower anchor belt by pressing down on belt adjuster slide button on

top of belt adjuster and pulling belt to extend the length of lower anchor belt (fig. c).

Lower

Anchor Belt

Pull

Belt Adjuster

Slide Button

(fig. c)	Belt
	Adjuster

6Check that the lower anchor belt is through the belt path openings marked “Belt Here

Forward-facing” (fig. d). If lower anchor belt is not through the forward-facing belt path openings, see “LATCH - Changing Belt Path Location” section.

7	Place car seat forward-facing in the
	vehicle seat location selected with
	forward-facing belt path toward vehicle	(fig. d)
	seat back and centered between the
	vehicle lower anchors (fig. d).	Forward-facing
8	Adjust car seat to desired recline position
		Belt Path
	1, 2 or 3.

-To change recline position, see “Recline Position Adjustment” section.

9Connect lower anchor connectors to vehicle lower anchors.

-Position the lower anchor belt with the belt adjuster

slide button facing away from the car seat. If the adjuster is not in that position, turn the belt and adjuster over. Check that lower anchor belt is flat,not twisted.

-With hook-on connector opening facing down 1 , position the opening of the connector over the vehicle lower anchor. Push down 2 and then pull out 3 on the connector to lock it onto the vehicle anchor (fig. e). You should hear a click.

-Pull on connector to be sure it is locked onto the anchor.

-Repeat for connector on

opposite side. 32

1

2

3

(fig. e)