Graco 313539F Motor Controls and Indicators, Motor ON/OFF Key/LED, Park Key/LED, Pressure Key/LED

Page 15

Motor Controls and Indicators

Motor Controls and Indicators

Pressure/Cycle Display

Arrow Keys

Motor ON/OFF Key

ON / OFF

PARK Key

Pressure Key

Cycle Count Key

PARK

PSI/BAR Keys

PSI

BAR

FIG. 6. Motor Controls and Indicators

Motor ON/OFF Key/LED

Press to turn motor ON and OFF. Also clears some motor control diagnostic codes, see page 35.

PARK Key/LED

Press at end of day to cycle component A pump

to home position, submerging displacement rod. Trigger gun until pump stops. Once parked, motor will automati- cally shut off.

Pressure Key/LED

Press to display fluid pressure.

NOTE:

If pressures are imbalanced, display shows higher of two pressures.

PSI/BAR Keys/LEDs

Press PSI or BAR to change pressure scale.

313539F

15

Image 15

Contents Operation Important Safety InstructionsModels ContentsRelated Manuals Supplied ManualsElectric Shock Hazard Fire and Explosion Hazard Moisture Sensitivity of Isocyanates Isocyanate ConditionsMaterial Self-ignition Keep Components a and B SeparateChanging Materials Typical Installation, with circulation Key for FIGSide Supply Detail Typical Installation, without circulation Reactor H-VR Component IdentificationInside cabinet Detail of Reactor Fluid Manifold Shroud removed for clarityDetail of Pump Assembly guard removed for clarity Pump AssemblyTarget Temperature Key/LED Temperature Controls and IndicatorsMain Power Switch Actual Temperature Key/LEDHeater Zone On/Off Keys/LEDs Temperature Scale Keys/LEDs Circuit BreakersTemperature Arrow Keys Temperature DisplaysPressure Key/LED Motor Controls and IndicatorsMotor ON/OFF Key/LED Park Key/LEDMotor Control Arrow Keys Spray AdjustmentsCycle Count Key/LED Hydraulic Pressure Control KnobSetup Locate ReactorGeneral equipment guidelines System Phase Amps Watts 256886 230V 26,600 256887 400VElectrical requirements See table Electrical Requirements kW/Full Load Amps VoltageInstall Fluid Temperature Sensor FTS Connect feed pumpsConnect pressure relief lines Pressure check hose Connect heated hoseClose gun fluid manifold valves a and B Connect whip hose to gun fluid manifoldCheck hydraulic fluid level Ground systemStartup Alaf Load fluid with feed pumps Set temperatures Temperature Controls and Indicators, see Set pressure Manual current control mode onlyAvailable Pressure Imbalance Settings Change pressure imbalance setting optionalSpray SprayingOpen gun fluid manifold valves a and B Shutdown StandbyPressure Relief Procedure Fluid Circulation Circulation Through ReactorPressure RELIEF/CIRCULATION CKR Circulation Through Gun ManifoldDiagnostic Codes Temperature Control Diagnostic CodesCode Code Name Alarm Zone Code Code Name Alarm or Motor Control Diagnostic CodesFrequency of Oil Changes Ambient Recommended Temperature MaintenanceFluid Inlet Strainer Fluid Inlet Strainer ScreenRELIEF/CIRCULATION FlushingDimensions Category Data Technical DataFlow Rate in gal/min liter/min Performance ChartsPressure in psi MPa, bar Flow Rate in lb/min kg/minFlow Rate in gpm lpm Delta T in degrees F degrees C313539F Graco Information Graco Standard Warranty