Graco 313539F important safety instructions Delta T in degrees F degrees C, Flow Rate in gpm lpm

Page 42

Performance Charts

Delta T in degrees F (degrees C)

140

(78)

130

(72)

120

(67)

110

(61)

100

(56)

90

(50)

80

(44)

70

(39)

60

(33)

50

(28)

40

(22)

30

(17)

20

(11)

10

(6)

Heater Performance Chart

H-VR

KEY

H-VR = 15.3 kW

0

0.5	1.0	1.5	2.0	2.5	3.0	3.5	4.0	4.5
(1.9)	(3.8)	(5.7)	(7.6)	(9.5)	(11.4)	(13.2)	(15.1)	(17.0)

Flow Rate in gpm (lpm)

★Heater performance data is based on testing with 10 wt. hydraulic oil and 230V across heater power wires.

42

313539F

Image 42

Contents Important Safety Instructions OperationContents ModelsSupplied Manuals Related ManualsElectric Shock Hazard Fire and Explosion Hazard Keep Components a and B Separate Isocyanate ConditionsMaterial Self-ignition Moisture Sensitivity of IsocyanatesChanging Materials Typical Installation, with circulation Key for FIGSide Supply Detail Typical Installation, without circulation Component Identification Reactor H-VRDetail of Reactor Fluid Manifold Shroud removed for clarity Inside cabinetPump Assembly Detail of Pump Assembly guard removed for clarityActual Temperature Key/LED Temperature Controls and IndicatorsMain Power Switch Target Temperature Key/LEDTemperature Displays Temperature Scale Keys/LEDs Circuit BreakersTemperature Arrow Keys Heater Zone On/Off Keys/LEDsPark Key/LED Motor Controls and IndicatorsMotor ON/OFF Key/LED Pressure Key/LEDHydraulic Pressure Control Knob Spray AdjustmentsCycle Count Key/LED Motor Control Arrow KeysSetup Locate ReactorGeneral equipment guidelines Electrical Requirements kW/Full Load Amps Voltage Phase Amps Watts 256886 230V 26,600 256887 400VElectrical requirements See table SystemInstall Fluid Temperature Sensor FTS Connect feed pumpsConnect pressure relief lines Connect whip hose to gun fluid manifold Connect heated hoseClose gun fluid manifold valves a and B Pressure check hoseGround system Check hydraulic fluid levelStartup Alaf Load fluid with feed pumps Set temperatures Temperature Controls and Indicators, see Manual current control mode only Set pressureChange pressure imbalance setting optional Available Pressure Imbalance SettingsSpraying SprayOpen gun fluid manifold valves a and B Standby ShutdownPressure Relief Procedure Fluid Circulation Circulation Through ReactorPressure RELIEF/CIRCULATION Circulation Through Gun Manifold CKRDiagnostic Codes Temperature Control Diagnostic CodesCode Code Name Alarm Zone Motor Control Diagnostic Codes Code Code Name Alarm orMaintenance Frequency of Oil Changes Ambient Recommended TemperatureFluid Inlet Strainer Screen Fluid Inlet StrainerFlushing RELIEF/CIRCULATIONDimensions Technical Data Category DataFlow Rate in lb/min kg/min Performance ChartsPressure in psi MPa, bar Flow Rate in gal/min liter/minDelta T in degrees F degrees C Flow Rate in gpm lpm313539F Graco Standard Warranty Graco Information