Startup
j.Manual current control mode only:
When in manual current control mode, monitor hose temperature with thermometer. Install per instructions below. Thermometer reading must not exceed 160°F (71°C). Never leave machine unattended when in manual current control mode.
If FTS is disconnected or display shows diag- nostic code E04, turn main power switch OFF
then ON | to clear diagnostic |
code and enter manual current control mode.
display will show current to hose. Current
is not limited by target temperature.
To prevent overheating, install hose thermome- ter close to gun end, within operator view. Insert thermometer through foam cover of A compo- nent hose so stem is next to inner tube. Ther- mometer reading will be about 20°F less than actual fluid temperature.
If thermometer reading exceeds 160°F (71°C),
reduce current with key.
4.Set pressure
ON / OFF
PARK
PSI
BAR
Motor Controls and Indicators, see page 15
a.Press to display the pressure reading.
b.Press motor . Motor and pumps start. Display shows system pressure.
NOTE:
Motor must rotate counterclockwise when viewed from shaft end. See Connect electrical cord, page 18.
c.Adjust hydraulic pressure control until display shows desired fluid pressure.
+-
ti7731ati7732a
NOTICE
Never adjust hydraulic pressure while spraying. This will result in over pressure alarm E23.
NOTE:
If display pressure is greater than desired pressure, reduce the hydraulic pressure and trigger gun to reduce pressure.
26 | 313539F |