CHAPTER 2 STANDARDS AND ADJUSTMENTS
2. Adjusting the AE Mechanism (VR602, VR603)
(Before Adjustment)
•Obtain a newspaper whose text consists of fine print; do not use a section with photos or large characters.
•Make sure you have adjusted light intensity.
1)Switch the copier OFF.
2)Detach the control panel cover.
3)Turn VR602 and VR603 on the control panel PCB fully clockwise.
4)Place a newspaper over the AE
AE
Figure 2-3B
5)Short the three jumper wires (JP604, JP605, JP607) on the control panel PCB at the same time using a screwdriver.
Caution:
Take adequate care not to short wires other than those specified.