CHAPTER 3 IMAGE TROUBLESHOOTING
14. The copy has faulty fixing.
Cause | Step | Checks | YES/NO | Remedies |
|
|
|
|
|
Copy paper | 1 | Is the copy paper of a type rec- | NO | Try paper of a recom- |
|
| ommended by Canon? |
| mended type; if the |
|
|
|
| results are good, advise |
|
|
|
| the user to use recom- |
|
|
|
| mended paper. |
|
|
|
|
|
Fixing film | 2 | Is the faulty fixing vertical and in | YES | Check the fixing film and |
|
| the form of lines? |
| pressure roller for |
|
|
|
| scratches. If scratches |
|
|
|
| are found, replace the |
|
|
|
| fixing unit or roller. |
|
|
|
|
|
DC controller/DC | 3 | Is the heater turned ON for | YES | The control temperature |
power supply PCB |
| control after copy operation is |
| for the fixing heater may |
|
| started? |
| be low; check the ther- |
|
|
|
| mistor and DC controller/ |
|
|
|
| DC power supply PCB. |
|
|
|
|
|
Fixing heater |
|
| NO | See “The fixing heater fails |
|
|
|
| to operate.” |
|
|
|
|
|
15.The copy has faulty leading edge registration (blank area much too wide).
16.The copy has faulty leading edge registration (blank area too wide).
17.The copy has faulty leading edge registration (no blank area).
Cause | Step | Checks | YES/NO | Remedies |
|
|
|
|
|
Registration cam | 1 | Move the registration cam on the | YES | Adjust the position of the |
|
| copyboard left and right. |
| registration cam. |
|
| Is there any change to the reg- |
|
|
|
| istration? |
|
|
|
|
|
|
|
Solenoid (SL1), | 2 | Is the solenoid for registration | NO | 1. Check the solenoid |
DC controller/DC |
| (SL1) operating normally? |
| (SL1). |
power supply PCB |
|
|
| 2. Check the DC con- |
|
|
|
| troller/DC power supply |
|
|
|
| PCB. |
|
|
|
|
|
3 | Is the copy paper of a type | YES | Check the | |
|
| recommended by Canon? |
|
|
Copy paper |
| NO | Try copy paper of a type | |
|
| |||
|
|
|
| recommended by Canon; |
|
|
|
| if the results are good, |
|
|
|
| advise the user to use |
|
|
|
| recommended paper. |
|
|
|
|
|