Yamaha CRW3200NB manual Preparing the CRW3200E Drive

Page 21

Preparing the CRW3200E Drive

The setting methods for most IDE devices are as follows.

•Hard drive: Change the setting with the jumper switch on the circuit board on the rear panel or the hard drive bottom panel. You have to set the cable select (CSEL) on some hard drives.

•CD-ROMs, etc.: Change the setting with the jumper switch on the rear panel.

Note

•When you use the IDE device as a master, connect the device to the connector at the end of the IDE cable, or when you use the device as a slave, connect the device to the middle of the cable.

•When you connect two IDE devices to one IDE cable, assign each as master or slave respectively. The CRW3200E drive is set at slave by default.

13

Image 21

Contents Page FCC Information U.S.A Achtung English Safety Precautions Iii Warranty Table of Contents High speed writing/reading Features of the CRW3200E DriveSafeBurn Enhanced stability writing technology High fidelity digital audioFront Panel Names and Functions of PartsNames and Functions of Parts Rear PanelHandling Discs Precautions on UseCopyright Disclaimer of IndemnityDiscs that can be written on Useable discsCD-R discs CD-RW discsPartial CAV Constant Angular Velocity Computer PC/AT compatible System RequirementsImage file Operating system OSSerial Number Preparing the CRW3200E DrivePreparing tools Serial NumberPreparing the CRW3200E Drive Decide the Installation MethodReplacing an existing IDE device with the CRW3200E drive Installing the CRW3200E drive as an additional driveExample 1 As a secondary slave For additional drive Examples of connecting the CRW3200E driveIDE Preparing the CRW3200E Drive Set the Jumper Switch Cable Select Csel Install the CRW3200E Drive Installing the CRW3200E drive as an additional driveReplacing Connect the included 40-pin IDE cable Audio CD playback Connect an audio cable if necessaryPreparing the CRW3200E Drive Analog connection Spdif Digital connectionTop Power connector Bottom Check Recognition of the CRW3200E Drive When using Windows 95/98/98 Second Edition/MeWhen using Windows XP When using Windows 2000 ProfessionalCheck When using Windows 2000 Professional/XPDMA Direct Memory Access Install CD Writing SoftwareLoading/Ejecting a Disc Loading/Ejecting a Disc Manually Ejecting a DiscIs the computer turned on? TroubleshootingIs the disc tray opened when the computer is restarted? Disc tray does not open when you press the eject buttonIs each IDE device set respectively? Is any CD writing software being used?No data can be read from a disc Disc is ejected without order or it comes out spontaneouslyFor Windows Me Playback of an audio CD CD-DA cannot be heardFor Windows XP Error message Buffer Underrun is displayed Other problemsIs the power capacity of your computer sufficient? Checking the firmware version in your CRW3200E drive FirmwareYamaha CD-R/RW Drive website For Windows 95/98/98 Second Edition/MeSupported Formats Write Read Play back *4 CRW3200E Drive SpecificationsData Capacity CRW3200E drive conforms to the following specifications CRW3200E Drive Specifications Safety/EMC ComplianceBuffer Underrun Protection Function Technical NotesWriting Methods Disc-at-Once DAOSession-at-Once SAO Track-at-Once TAOPacket Writing Canada