JAI M7+ CL, CV-M4+, CV-M7+, M4+ CL operation manual Specification table, Specifications

Page 28

CV-M4+/M4+CL, CV-M7+/M7+CL

9.2. Specification table

 

 

 

 

Specifications

CV-M4+/CV-M4+CL

 

CV-M7+/CV-M7+CL

Scanning system

Progressive 1060 lines 24 frames/sec.

Pixel clock

40.49 MHz

 

40.49 MHz

Line frequency

25.43 kHz (1592 pixel clock/line)

 

25.43 kHz (1592 pixel clock/line)

Line freq. with V binnig

25.11 kHz (1752 pixel clock/line)

 

-

Frame rate for full frame

24 frames/sec. (1060 lines/frame)

 

24 frames/sec. (1060 lines/frame)

Frame rate for V binning

44 frames/sec. (565 lines/frame)

 

-

CCD sensor

2/3” progressive scan monochrome

 

2/3” progressive scan RGB primary color

 

IT CCD (ICX285AL)

 

(Bayer filter) IT CCD (ICX285AQ)

Sensing area

8.9 (h) x 6.6 (v) mm

Cell size

6.45 (h) x 6.45 (v) m

Effective pixels

1392 (h) x 1040 (v)

Pixels in video output

 

 

 

Full

1380 (h) x 1030 (v) 24 frames /sec.

 

1380 (h) x 1030 (v) 24 frames /sec.

V binning

1380 (h) x 515 (v) 44 frames/sec.

 

-

1/2 partial

1380 (h) x 512 (v) 44 frames/sec.

 

1380 (h) x 512 (v) 44 frames/sec.

1/4 partial

1380 (h) x 256 (v) 70 frames/sec.

 

1380 (h) x 256 (v) 70 frames/sec.

1/8 partial

1380 (h) x 128 (v) 102 frames/sec.

 

1380 (h) x 128 (v) 102 frames/sec.

Sensitivity on sensor

0.1 Lux (Max. gain, 50% video)

 

0.1 Lux (Max. gain, 50% video)

S/N ratio

>57 dB

 

>57 dB

Video A/D conversion

 

10

bit

Video output digital

8 bit in LVDS (EIA 644). 10 bit in Camera Link. (CL versions)

Video output analogue

0.7 Vpp, 75 (For test only)

Gamma

 

1.0

Gain

Manual

Gain range

-3 to +12 dB

Synchronization

Int. X-tal. Ext. random trigger

Sync. output *)

Composite 4 Vpp from 75

Trigger input TTL *)

4 V ±2 V

EEN output *)

4 Vpp from 75

Pixel clock output

LVDS or Camera Link

LEN output

LVDS or Camera Link

FEN output

LVDS or Camera Link

Trigger input *)

TTL, LVDS or Camera Link

Multiple exposure *)

TTL, LVDS or Camera Link

Trigger modes

Continuous, Edge pre-select, Pulse width control, Frame delay, Reset Continuous

 

Trigger

Trigger input (Edge pre-s)

>2 H to < 4000 H. (H synchronous H a-synchronous accumulation)

Shutter speed (fixed)

1/24, 1/50, 1/100, 1/200, 1/400, 1/800, 1/1500, 1/3000, 1/5000, 1/10,000 s

Pulse width control

2 H to . (80 sec. to ) <2 second is recommended

Frame-delay readout

Fixed shutter speeds. Delay 3 frames

Smearless readout

Edge pre-select, PWC and frame delay

Multiple exposure

6 fixed exposures in frame-delay readout.

Interval between exp.

Fixed shutter time + 1H (40 sec.)

Switches on rear

Shutter, trigger, scanning, smearless, RS 232C control

Functions controlled by

Shutter, Trigger, Scanning, Readout, Trigger input, Select/polarity, LEN/FEN/EEN

RS 232C

polarity, Video level, Set-up level and Gain

Operating temperature

-5°C to +45°C

Humidity

20 – 80% non-condensing

Storage

-25°C to 60°C 20 to 90% non-condensing

Power

12V DC ± 10%. 3.3 W

Lens mount

C-mount

Dimensions

40 x 50 x 90 mm (HxWxD)

Weight

 

250g

*) Alternative inputs or outputs

- 27 -

Image 28
Contents CV-M4+/M4+CL CV-M7+/M7+CL CV-M4+/M4+CL, CV-M7+/M7+CL General Main FeaturesStandard Composition Locations and Functions LocationsDigital Output Connector for EIA-644 Lvds Pin Multi-connector DC-IN/RS232CPin Assignment Video signal, LEN, FEN Digital Output Connector for Camera LinkDval and EEN Input and Output Circuits Video outputTrigger input Multi Shutter input Composite Sync outputCamera Link interface MUXFunctions and Operations CV-M4+Block DiagramBasic functions Binning Color versions CV-M7+and CV-M7+CL Color coding from a Primary RGB CCD Bayer filterOutput of Timing Signals Restart Continuous Trigger mode. RCTContinuous Operation Non triggered Polarity and other functionsVertical timing details, full frame Vertical timing details with 1/2 partial scanning External Trigger Modes Accumulation latency time for H a-synchronous triggerEdge Pre-select Mode Important notes on using this modeEdge Pre-select, smearless Pulse Width Control Mode Pulse WidthFrame-delay read out Mode Frame DelayFrame-delay read out Mode with multiple exposure Multiple exposure, normal and smearlessOther Functions Gain and set-upConfiguring the Camera Mode setting SW1 on rearMode setting SW301 inside Internal Switch and Jumper SettingsRS-232C control CV-M4+command list Timing and shutter related commandsCamera Control Tool for CV-M4+ Specifications External Appearance and DimensionsSpectral sensitivity Specification table SpecificationsTypical CCD Characteristics PrecautionsAppendix Camera Link Test points Camera Link test pointsUsers Mode Settings Users Modifications Users Record