JAI CV-M4+, M7+ CL, CV-M7+, M4+ CL operation manual Pin Assignment, Pin Multi-connector DC-IN/RS232C

CV-M4+/M4+CL, CV-M7+/M7+CL

5. Pin Assignment

5.1. 12-pin Multi-connector (DC-IN/RS232C)

Type: HR10A-10R-12PB-01 (Hirose) male. (Seen from rear of camera.)

1 9

2 10 8

3 11 12 7

46

5

Fig. 2. 12-pin connector.

Pin no. Signal Remarks

1GND

2+12 V DC input

3GND

4Video output Analogue video for test and iris control *)

5GND

6	RXD in	Or via Camera Link for CL+ versions
7	TXD out	if JP 301 short

8GND

9 EEN/sync out *1) composite sync.

10Trigger input *2) Or on LVDS or Camera Link.

11Multi shutter *2) Or on LVDS or Camera Link.

12GND

*) Iris video out without sync. Refer to 5.4.1 video output *1) EEN or c. sync out select by RS232C command SE

*2) input on 12-pin con. or LVDS/(CL) by command TP or int. SW301-1

5.2.Digital Output Connector for EIA-644 (LVDS)

This pin configuration is only valid for CV-M4+/ CV-M7+

Type: 26 pin MRD connector		Pin no.		Signal		Function	Remarks
		1	14	+/- D2	Video output (LSB)
3M 10226-1A10JL
		2	15	+/- D3		Video output
13	1
		2	16	+/- D4		Video output	8 most significant bits
		4	17	+/- D5		Video output
							of the 10 bit digitized
		5	18	+/- D6		Video output
							video
26	14	6	19	+/- D7		Video output
		7	20	+/- D8		Video output
Fig. 3. LVDS connector		8	21	+/- D9	Video output (MSB)
The digital input and output		9	22	+/-TRIG	Trigger input		*1) or TTL on #10 12 pin
		10	23	+/-Multi	Multiple exposure		*1) or TTL on #11 12 pin
signals follow the EIA 644		11	24	+/-LEN	Line enable
standard. It is also called Low		12	25	+/-FEN		Frame enable
Voltage Differential Signal		13	26	+/-PCLK		Pixel clock
(LVDS). The output differential
line driver is NS type DS90C031.			*1) input on 12-pin con. or LVDS/(CL) by command TP or int. SW301-1
Line receiver is NS type DS90C032.
The following signal are found on the Digital Output Connector:
D2 – D9	8 bit video Data out.
PCLK	Pixel CLocK. One clock pulse for each video data byte.
LEN	Line ENable. A pulse for the beginning of each new line.
FEN	Frame Enable. Video frame out data is valid.
Multi	Multiple shutter. Trigger input for multiple exposures.
Ext. Trigger IN	External trigger signal in for exposure control.

The polarity for LEN, FEN, TRIG is negative and Multi is positive as factory setting. It can be changed by internal SW301-2 and 3 or RS 232C command FP and TP

- 4 -