NAD C340 Troubleshooting, No Sound ONE Channel, Remote Control Handset, Not Working

TROUBLESHOOTING

Problem	Cause	Solution
NO SOUND	• Power AC lead unplugged or power not	• Check if AC lead is plugged in and
	switched on	power switched on
	• Tape 2 Monitor selected	• De-select Tape 2 Monitor mode
	• Mute on	• Switch off Mute
	• Rear Pre-out/Main-in amp links not	• Fit links
	fitted
	• Headphones inserted	• Disconnect headphones
NO SOUND ONE CHANNEL	• Balance control not centered	• Center Balance control
	• Speaker not properly connected or	• Check connections and speakers
	damaged
	• Input lead disconnected or damaged	• Check leads and connections
WEAK BASS / DIFFUSE STEREO IMAGE	• Speakers wired out of phase	• Check connections to all speakers in
		the system
REMOTE CONTROL HANDSET	• Batteries flat, or incorrectly inserted	• Check or replace batteries
NOT WORKING	• IR transmitter or receiver windows	• Remove obstruction
	obstructed	• Place unit away from direct sun, reduce
	• IR receiver in direct sun or very bright	amount of ambient light
	ambient light

GB

7