Yamaha RX-SL80 owner manual Presetting stations, Automatically presetting FM stations

TUNING

Presetting stations

■Automatically presetting FM stations

You can use the automatic preset tuning feature to store FM stations. This function enables this unit to automatically tune in to FM stations with strong signals, and to store up to 40 (8 stations x 5 groups) of those stations in order. You can then recall any preset station easily by selecting the preset station number.

INPUTVOLUME/SELECT

							VOLUME/SELECT
					TUNER	DSP	INPUT
STANDBY	SILENT CINEMA	VIDEO	L	AUDIO R	OPTICAL
/ON
					AUTO/MAN'L
							PUSH-ENTER
	PHONES			VIDEO 2

1Press INPUT, then rotate VOLUME/SELECT within 5 seconds to select TUNER.

VOLUME/SELECT

INPUT

Note

If no operation is performed within 5 seconds of pressing INPUT or VOLUME/SELECT is pressed on the front panel, the function of VOLUME/SELECT switches back to volume level adjustment. If this happens, “VOLUME” appears in the front panel display for a few seconds.

2Press INPUT repeatedly on the front panel to select the FM band you want to preset.

“FM” appears in the front panel display.

INPUT

3Hold down VOLUME/SELECT for more than 5 seconds.

The “AUTO” and “MEMORY” indicators flash in the display and after about 5 seconds, automatic presetting starts from the lowest frequency, proceeding to higher frequencies.

VCR VIDEO 1 VIDEO 2 DTV/CBL DVD/CD TUNER

VOLUME

AUTO MEMORY

L R

When automatic preset tuning is completed, the front panel display shows the frequency of the last preset station.

Notes

•Any stored station data existing under a preset number is cleared when you store a new station under that preset number.

•If the number of the received stations does not reach E8, automatic preset tuning automatically stops after searching all stations.

•Only FM stations with sufficient signal strength are stored automatically by automatic preset tuning. If the station you want to store is weak in signal strength, tune in to it manually in the monaural mode, and store it by following the procedure in “Manually presetting stations”.

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the preset stations may be cleared. If so, store the stations again by using the presetting station methods.

24