CSP Distance, Dcenter GEQ, Elfe Level

SET MENU

■Speaker distance C)SP DISTANCE

Use this feature to manually input the distance of each speaker and adjust the delay applied to respective channel. Ideally, each speaker should be the same distance from the main listening position. However, this is not possible in most home situations. Thus, a certain amount of delay must be applied to the sound from each speaker so that all sound will arrive at the listening position at the same time.

C)SP DISTANCE

. UNIT;;;;;;meters

;;;;3.00m

;;;;;3.00m

Unit UNIT

Choices: meters (m), feet (ft)

Initial setting:

U.S.A. and Canada models: feet (ft)

Other models: meters (m)

•Select meters to input speaker distances in meters.

•Select feet to input speaker distances in feet.

Speaker distances

Choices: 0.3 to 24.00 m (1 to 80 ft)

•FRONT L adjusts the distance of the front left speaker. Initial setting: 3.0 m (10.0 ft)

•FRONT R adjusts the distance of the front right speaker. Initial setting: 3.0 m (10.0 ft)

•CENTER adjusts the distance of the center speaker. Initial setting: 3.0 m (10.0 ft)

•SURR L adjusts the distance of the surround left speaker. Initial setting: 3.0 m (10.0 ft)

•SURR R adjusts the distance of the surround right speaker. Initial setting: 3.0 m (10.0 ft)

•SWFR adjusts the distance of the subwoofer. Initial

setting: 3.0 m (10.0 ft)

■Center graphic equalizer D)CENTER GEQ

Use this feature to adjust the built-in 5-band graphic equalizer for the center channel so that the tonal quality of the center speaker matches that of the front speakers. You can make adjustments listening to the currently selected source component or a test tone.

You can adjust 5 frequency bands: 100Hz, 300Hz, 1kHz, 3kHz, 10kHz

Choices: –6 to +6 dB

D)CENTER GEQ

. )OFF

•Select ON to output test tones from the front left and center speakers, and adjust the tonal quality of the center speaker.

•Select OFF to stop the test tone and output the currently selected source component.

•Press u / dto select a frequency band.

•Press j/ ito adjust the selected frequency band.

■Low-frequency effect level E)LFE LEVEL

Use to adjust the output level of the LFE (low-frequency effect) channel according to the capacity of your subwoofer or headphones. The LFE channel carries low- frequency special effects which are only added to certain scenes. This setting is effective only when this unit decodes Dolby Digital or DTS signals.

Choices: –20 to 0 dB

E)LFE LEVEL

. ;;;;;;0dB

;;;;0dB

Speaker SPEAKER

Select to adjust the speaker LFE level.

Headphone HEADPHONE

Select to adjust the headphone LFE level.

Note

Depending on the settings of “LFE LEVEL”, some signals may not be output from the SUBWOOFER OUTPUT jack.