Yamaha RX-SL80 Pre-adjusting the subwoofer vol- ume, Adjust the volume of the entire sound system

Using the subwoofer (SW-P240)

1

2

VOLUME

3

INPUT

4 POWER

ON

OFF

Rear panel

	VOLUME
	INPUT
	POWER
	ON
	OFF
110V-120V	VOLTAGE
220V-240V	SELECTOR

Pre-adjusting the subwoofer vol- ume

Before you use the subwoofer, first adjust the vol- ume balance between the subwoofer and the front speakers by following the procedure below.

1. Set the VOLUME control to minimum (0).

2. Turn on the power to all other components.

3. Press the POWER switch to the ON position.

The power indicator on the rear panel lights up

green.

4. Play a source that contains low-frequency

sounds. Adjust the amplifier’s volume control to

the desired listening level.

5. Increase the volume gradually to adjust the vol-

ume balance between the subwoofer and the

front speakers. In most cases, set the control to a

level at which you hear slightly more bass than

when the subwoofer is not used.

1Power indicator

Lights up GREEN when the POWER switch

(4) is turned ON; turns off when the POWER switch is turned OFF.

2VOLUME control

Adjusts the volume level. Turn the control clockwise to increase the volume, and counter- clockwise to decrease the volume.

3INPUT terminal

Input terminal for line level signals from the amplifier.

4POWER switch

Press this switch to the ON position to turn on the power to the subwoofer. When the power of the subwoofer is on, the power indicator (1) on the rear panel lights up green. Press this switch again to set it to the OFF position to turn off the power of the subwoofer.

6. Adjust the volume of the entire sound system

using the amplifier’s volume control.

•If you replace the front speakers (NX-S120) with other speakers, you must again balance the subwoofer and surround speaker volume.

•For more information on adjusting the VOLUME control, refer to “Frequency characteristics” on page 11.

8