Changing the RDS mode
The four modes are available in this unit for displaying RDS data. The PS, PTY, RT and/or CT mode indicators that correspond to the RDS data services offered by the station light up in the front panel display. Press FREQ/ RDS on the remote repeatedly to change the display mode among the RDS data offered by the transmitting station in the order shown below.
FREQ/RDS
s 
PS
PTY
RT
CT
Frequency
display mode
Notes
•Do not press FREQ/RDS until one or more RDS mode indicators light up in the front panel display. You cannot change the mode if you press the button prior to this. This is because this unit has not finished receiving all of the RDS data from the station.
•RDS data not offered by the station cannot be selected.
•This unit cannot utilize the RDS data source if the signal received is not strong enough. In particular, the RT mode requires a large amount of data, so it is possible that the RT mode may not be displayed even if other RDS modes (PS, PTY, etc.) are displayed.
•RDS data may not be received under poor reception conditions. In such cases, press TUNER (AUTO/MAN’L) so that the “AUTO” indicator disappears from the front panel display. Although this will change the reception mode to manual, RDS data may be displayed when you change the display to RDS mode.
•If the signal strength is weakened by external interference during the reception of an RDS station, the RDS data service may be cut off suddenly and “...WAIT” will appear in the front panel display.
TUNING
PTY SEEK function
If you select the desired program type, this unit automatically searches all preset RDS stations that are broadcasting a program of the required type.
1Press PTY SEEK MODE to set this unit in the PTY SEEK mode.
The program type of the station being received or “NEWS” flashes in the front panel display.
MODE PTY SEEK START
e f
Flashes
2Press u PRESET d to select the desired program type.
The selected program type appears in the front panel display.
d PRESET u
p a
3Press PTY SEEK START to begin searching all preset RDS stations.
The selected program type flashes and the “PTY HOLD” indicator lights up in the front panel display while searching for stations.
MODE PTY SEEK START
e f | PTY HOLD |
Lights up
•The unit stops searching when it finds a station broadcasting the selected type of program.
•If the found station is not the one you desire one, press PTY SEEK START again. This unit resumes searching for another station broadcasting the same type of program.
To cancel this function
Press PTY SEEK MODE twice.
OPERATION | BASIC |
|
|
English
27