Yamaha RX-V1065 owner manual 67 En, ProblemCause, Disturbed, Remedy See

ProblemCause

The picture isThe video software is copy-protected.

disturbed.

No sound.	Incorrect	input	or output cable
	connections,
	No appropriate		input	source	has been
	selected,
	Speaker	connections		are not	secure.

The volume is turned clown or muted.

Signals this unit cannot reproduce are being input from a source component, such as a CD-ROM.

The HDMI components connected to this unit do not support the HDCP copy protection standards.

"Audio Output" in "HDM]" is set to "TV".

A proper audio decoder is not selected.

Only the centerWhen a monaural source sound fiekt

speaker outputsprogram is applied, sound of all channels

substantial sound,are output from the center speaker for some surround decoders.

The playback component or speakers are not connected properly,

No sound is output Output from that speaker is disabled.

from a specific

speaker,

The volume of that speaker is set to minimum in "Speaker Setup" in the "Setup" nlenu.

This unit is in the straight decode mode.

Sound may not be output from certain channels depending on input sources or sound fiekt programs.

The speaker is malfunction.

			Remedy					See
								page
Connect	the cables		properly.	If	the	problem persists,		15
the cables		may be defective.
Rotate	the	@INPUT	selector		(or	press	[_nput	22
selection		key)	to select	the desired			input source.
Secure	the	connections.						11
Turn up the volume.								22

Display "Signal Int_" in the Option menu and check the input signal t_rmat.

lf"No Signal" is displayed, check if the playback component is properly connected to this unit (or a proper input source is selected).

If" " is displayed, the input signal in that format cannot be reproduced by this unit.

Connect	HDMI		components		that	support	the HDCP	81
copy protection			standards.
Set "Audio		Output"		(Function	Setup -9 HDMI =->			58
Audio Output) to the other setting.
Display	the	Option		menu and	set	"Decoder	Mode" to	47
"Auto".
Try another		sound		field program.				25

Connect	the cables		properly.	If the problem persists,			12,	15
the cables		may be	defective.
Check	the	Speaker	indicators	on the	front	panel	6, 22,	25,
display.	If	the corresponding		indicator	is	turned oft',	55
try the	t_llowing.

1)Change the input source to another one.

2)With the selected sound field program, sound is not output from that speaker. Select another sound fiekt program.

3)"None" may have been selected for that speaker on this unit. Display "Speaker Setup" in the "Setup"

menu and enables output of that speaker.

Display "Speaker	Setup"	in the "Setup" menu	and	57
adjust the volume	(Manual Setup =->Speaker		Level).
Press (_STRAIGHT	(or	_STRAIGHT)	to turn	28
off the straight decode mode.
Try another sound	fiekt program.			25

Check the speaker indicators on the front panel

display. If the corresponding indicator lights up, connect another speaker and check if sound is output. If sound is not output, this unit may be malflmction.

67En