Yamaha RX-V1065 owner manual After Auto Setup, 76 En, 8NO Signal, Error, 4CHECK Prns

D I!"i'g/_ _ r_Ik_ a2"i'!_ i i a_•r

Error message		Cause
E-7:NO MIC	The optimizer	microphone	"a,as
	unplugged during the "Auto Setup"
	procedure.
E-8:NO SIGNAL	The optimizer	microphone	does not
	detect test tones.

E-9:USERCANCEL"Auto Setup" was canceled due to an

inappropriate user operation.

E-10:INTERNAL An internal error occurred.

ERROR

						Remedy				See
										page
Do not		touch the			optimizer		microphone during "Auto			19
Setup".
Check		whether			the	microphone		is properly	placed.	19
Check		whether		the		speakers	are	properly	placed and	10, 11
connected.
The	optimizer			microphone			or OPTIMIZER		MIC
jack may be defective. Contact the nearest Yamaha
dealer		or service			center.
Run	"Auto		Setup"			again.				19
Run	"Auto		Setup"			again.				19

After Auto Setup

Error message Cause

W-1 :OUT OF PHASESpeaker polarity is not correct. This message may appear depending on the speakers even when the speakers are connected correctly.

W-2:OVER 24m (8Oft) The distance between the speaker and the listening position is over 24 m (80 ft).

W-3:LEVEL ERRORThe difference of volume level among speakers is excessive,

W-4:CHECK PRNS	Presence speakers were not detected
	during measurement with ='Extra Speaker
	Assignment" set to "Presence".

			Remedy		See
					page
Check	the	polarities	(+,)	of the displayed speaker.	12
If they are correct, the speakers work properly even
when this message is displayed.
Bring the speaker within 24 m (80 ft.) area around
the listening		position.
Recheck the speaker positions and make sure all
speakers are placed in a similar environment.
Check	the	polarities	(+,)	of the speakers.	12

We recommended that you use speakers with the same or similar specifications.

Adjust the output volume of the subwoofer.

Check	the	presence		speaker	connections	and pert_rm		11, 56
measurement			again.	If presence speakers		are	not
connected,		set the "Extra			Speaker Assignment"		to
other	than		"Presence".

76En