Yamaha RX-V1065 owner manual Switching to the Zone2 operation mode

Ill_lar, l,,I,lfl=._,Jar_,_,mlt,{,l(q((q t

You can select and control Zone2 by using the control keys on the front panel or on the remote control. The available operations are as follows:

° Selecting the input source.

*Tuning into the desired station (when "TUNER" is selected as the input source)

*Tuning into the desired channel (when "XM" or "SIRIUS" is selected as the input source) (U.S.A. model only)

*Adjusting the volume of Zone2 (when Zone2 speakers are connected to the EXTRA SP terminals).

Switching to the Zone2 operation mode

Before controlling Zone2 by using the control keys on the front panel or on the remote control, follow the procedure below to switch this unit to the Zone2 operation mode.

•To control Zone2 by using the front panel control keys

Press @ZONIE2 CONTROL while Zone2 is turned on.

The ZONE2 indicator flashes on the front panel display

for approximately 10 seconds.

..... Z02NE ..... Flashes

• Select "DOCK" to use the iPod features (page 42) or Bluetooth features (page 44) in Zone2.

° Select "SIRIUS" to use the SIRIUS Satellite Radio features (page 37) in Zone2.

•Select "XM" to use the XM Satellite Radio features (page 33) in Zone2.

•Complete each step while the ZONE2 indicalor is flashing on tile front panel display. Otherwise, Ihe Zone2 mode is automatically canceled and this unil returns to the main zone operation mode.

•To control Zone2 by using the remote control

Switch [_MAIN/ZONIE2 to the "ZONE2" position.

Operations in the Zone2 operation mode

•Turning on or set Zone2 to standby Press @ZONE2 ON/OFF (or []POWER).

•Operating Zone2

Rotate the @INPUT selector (or press [_lnput

selection key) to select the desired input source.

° Select "AV5", "AV6", "AUDIOI", "AUDIO2", "V-

AUX" or "PHONO" to listen to the input source in Zone2.

*Select "TUNER" to use the FM/AM radio features (page 29) in Zone2.

*Select "USB" to use the USB features (page 45) in Zone2.

62En