Alarm Detect 26x Model Only, Threshold, IR Color

Philips Orion/2 Alarm Detect 26x Model Only, Threshold, IR Color, Detect Switch, Detect Mode

Page 39

Orion/2 Outdoor

•ON

Select the item to remove the IR cut filter.

23x Model:

IR FUNCTION
THRESHOLD	LOW
IR COLOR	COLOR
EXIT	YES

•AUTO

The Internal circuit will automatically decide the occasion to remove the IR cut filter according to the image brightness level.

THRESHOLD

The dome will remove the filter immediately when the threshold value is reached. The threshold options are <LOW>, <MID> and <HI>. <LOW> threshold indicates a higher sensitivity and can improve the reliability of lens.

IR COLOR

When IR function is enabled, the video output can be programmed as color or B/W.

•ON

Select the item to remove the IR cut filter.

3.3.18ALARM DETECT (26x Model Only)

This function instructs the camera to detect movement within the monitoring area and then send an alarm signal automatically. To activate this function, alarm connection setups most be completed in advance.

ALARM DETECT
DETECT SWITCH	OFF
DETECT MODE	INT. FOCUS
EXIT	YES

•DETECT SWITCH

The item is used to enable or disable the ALARM DETECTION function.

•DETECT MODE

Four alarm detect modes are provided for different application.

Image 39

Contents

Installation & User Instructions Orion/2 Outdoor Regulation Copyright Important InformationNever face the camera towards the sun Handle the camera carefullyDo not disassemble the camera Do not block cooling holes on the bracketConnecting the High Speed Dome Operation and ConfigurationOverview Appendix C Protocol-Pelco Appendix D Philips Allegiant Appendix a Technical Specification Appendix B Ernitec ErnaOverview Product Features Package Content Connecting the High Speed DomeCommunication Switch Setting Switch DefinitionDome Control Protocol Dome ID Setting2400 22-Pin Connector Definition11~20 Pin CableAlarm Pin Definition RS-485 ConnectorFor connection to Ernitec equipment, use Rx+ and Rx OSD Display Format Operation and Configuration1 26x Model OSD Menu TreeCruise 2 22x / 23x Model WDR Setting Schedule Reset Schedule Exit Configuration Menu Default Camera26x Model 22/23x Model Auto BacklightFocus 26x ModelManual ApertureGain AE ModeBright ShutterAGC WBC ModeATW ID DisplayIndoor OutdoorSetup Menu OFFImage Zoom Speed 23x Model Slow ShutterLast Setup MENU2 26x Model OnlyTitle Display FirstAlarm Setting Title SettingAlarm Action Alarm PINAlarm Switch Alarm TypeHome Setting Select Mode SequenceReturn Time Speed Preset PositionSequence Line Sequence Point Start Point Autopan Dwell Time RUN Sequence Autopan LineRUN Autopan CruiseEND Point DirectionRUN Cruise IR Function Removable IR CutRecord Start Record ENDThreshold Alarm Detect 26x Model OnlyDetect Switch Detect ModeWDR Setting 23x Model Only Transparency Privacy SwitchPrivacy WDR FunctionSize 00~80 ColorSET Mask CenterSize 000~127 Mask CLEAR+RESETShade Center 000~256Year / Month / DAY Time FunctionSchedule Function Time DisplayExit OSD Appendix a Technical Specification Appendix B Ernitec Erna Run Preset Tour Iris functionCruise Tour Cable Length Symbol DefinitionControl Dome Camera Using Pelco Keyboard Special FunctionCable Definition D Protocol Keyboard to Speed Dome Cable Definition P Protocol Keyboard to Speed DomeAppendix D Philips Allegiant Control Dome Camera Using Allegiant Keyboard26x Model OSD Menu NotesAutopan 22/23x Models WDR Setting

Philips Orion/2 Alarm Detect 26x Model Only, Threshold, IR Color, Detect Switch, Detect Mode