Sanyo VCC-WB4000P Saving to an Expansion Memory Card, Insert the expansion memory card

Alarm Settings

Saving to an Expansion Memory Card

If you would like to save and play back several sets of alarm data from the camera’s internal memory, use a CompactFlash memory card with a capacity of 16MB or greater.

CompactFlash memory cards are only used to store alarm data that has been recorded into the internal memory. This means that you cannot directly record data onto the CompactFlash memory cards or directly play back the data they contain.

1 Insert a memory card into the PC card slot at the rear of the camera, while making sure that the direction of the card is correct, and then push the knob down in the direction of the arrow.

This will lock the card in place.

To remove the card, push the knob in the direction of the arrow to release the card.

A2

1

2 Insert the expansion memory card.

The alarm data in the internal memory will be automatically moved to the memory card.

The data will be deleted from the recording areas of the internal memory at this time.

(Orange)(Orange)

3 The ALARM DATA indicator (green) will illuminate.

If alarms are repeatedly detected in this condition, the alarm data will be automatically moved to the memory card.

(Green)

Note:

•If there is no free space on the memory card, the indicator will illuminate red. If this happens, replace the memory card with another card or delete the alarm data.

•When inserting and removing the memory card, make sure that F ALARM BUFFERING is set to “OFF”, and then turn off the power. (p. 34)

•The PC card slot is for 16-bit 5 V cards only. Do not use 32-bit card bus types of card, as the terminal sections are different.

•New alarms cannot be received while alarm data is being moved onto the memory card.

•The camera is not equipped with a formatting function. Use the computer to format the memory card (only FAT formatting is supported).

– 42 – English