Seagate ST373307FC, ST336607FC Australian C-Tick, Korean MIC, Taiwanese Bsmi, Reference documents

Page 14

4	Cheetah 10K.6 FC Product Manual, Rev. B

Australian C-Tick

If this model has the C-Tick Marking it complies with the Australia/New Zealand Standard AS/NZS3548 1995 and meets the Electromagnetic Compatibility (EMC) Framework requirements of Australia’s Spectrum Man- agement Agency (SMA).

Korean MIC

If this model has the Korean Ministry of Information and Communication (MIC) logo, it complies with paragraph 1 of Article 11 of the Electromagnetic Compatibility (EMC) Control Regulation and meets the Electromagnetic Compatibility Framework requirements of the Radio Research Laboratory (RRL) Ministry of Information and Communication Republic of Korea.

Taiwanese BSMI

If this model has two Chinese words meaning “EMC certification” followed by an eight digit identification num- ber, as a Marking, it complies with Chinese National Standard (CNS) 13438 and meets the Electromagnetic Compatibility (EMC) Framework requirements of the Taiwanese Bureau of Standards, Metrology, and Inspec- tion (BSMI).

2.2Reference documents

Cheetah 10K.6 FC Installation Guide

Seagate part number: 100195492
Fibre Channel Interface Manual
Seagate part number: 77767496
ANSI Fibre Channel Documents
X3.230-1994	FC Physical and Signaling Interface (FC-PH)
X3.297.1997	FC-PH-2 Fibre Channel Physical and Signaling Interface-2
X3.303.1998	FC-PH-3 Fibre Channel Physical and Signaling Interface-3
X3.272-1996	FC Arbitrated Loop (FC-AL)
X3.269-1996	Fibre Channel Protocol for SCSI (FCP)
NCITS TR-19	Private Loop SCSI Direct Attach (PLDA)
NCITS TR-20	Fabric Loop Attachment (FC-FLA)
SFF-8045	Specification for 40-pin SCA-2 Connector with Parallel Selection
SFF-8067	Specification for 40-pin SCA-2 Connector with Bidirectional Enclosure Services
	Interface
ANSI Small Computer System Interface (SCSI) Documents
X3.131-1994	(SCSI-2)
X3.270-1996	(SCSI-3) Architecture Model
NCITS 305-199X (SCSI-3) Enclosure Services
Specification for Acoustic Test Requirement and Procedures
Seagate part number: 30553-001
Package Test Specification		Seagate P/N 30190-001 (under 100 lb.)
Package Test Specification		Seagate P/N 30191-001 (over 100 lb.)

In case of conflict between this document and any referenced document, this document takes precedence.

Image 14

Contents Page Page Page Page Revision status summary sheet Revision Date Writer/Engineer Sheets AffectedPage Contents Seagate Technology support services Defect and error managementInstallation Interface requirementsList of Figures Cheetah 10K.6 FC Product Manual, Rev. B ViiPage Scope Cheetah 10K.6 FC family disc driveCheetah 10K.6 FC Product Manual, Rev. B Applicable standards and reference documentation Taiwanese Bsmi Australian C-TickKorean MIC Reference documentsGeneral description Cheetah 10K.6 FC disc drivePerformance Standard featuresMedia description ReliabilityUser-installed accessories Factory-installed accessoriesFactory-installed options Unformatted and formatted capacitiesCheetah 10K.6 FC Product Manual, Rev. B Seek performance characteristics Access time Performance characteristicsInternal drive characteristics Format command execution time in minutesPrefetch/multi-segmented cache control General performance characteristicsStart/stop time Cache operationCaching write data Prefetch operation Reliability specifications Service life Reliability and servicePreventive maintenance Service philosophyPerformance impact 7 S.M.A.R.TControlling S.M.A.R.T Determining rate MillisecondsReporting control Predictive failuresInvoking DST State of the drive prior to testingImplementation Short and extended testsAbort Product warrantyLog page entries ShippingDC power requirements Physical/electrical specificationsAC power requirements General DC power requirement notesCurrent profiles Power sequencingConducted noise immunity +5V +12VTypical ST373307FC drive +12V current profile Typical ST3146807FC drive +5V current profile Typical ST373307FC drive +5V current profile Power dissipation ST3146807FC ST373307FCTemperature Cheetah 10K.6 FC Product Manual, Rev. B ST336607FCShock and vibration Relative humidityEffective altitude sea level ShockPackage size Packaged/product weight Drop height Recommended mounting Acoustics Air cleanlinessCheetah 10K.6 FC Product Manual, Rev. B Vibration Mechanical specifications Mounting configuration dimensionsDrive error recovery procedures Defect and error managementDrive internal defects/errors Read and write retry count maximum recovery times Read retry Maximum recovery time per Write retryFC-AL system errors Maximum recovery time perLED connections InstallationDrive ID/option selection Drive orientation 1 J6 connector requirementsDrive Front CoolingDrive mounting Air flowGrounding Interface requirements FC-AL featuresFibre Channel link service frames Fibre Channel task management functionsFibre Channel port login NPort login Plogi payload BytesNPort Login Accept ACC payload Bytes Fibre Channel Process LoginFibre Channel Process Login Accept Process Login Plri payloadFibre Channel fabric login Fabric Login Flogi payload BytesFabric Login Accept ACC payload Bytes Accept or NPort Login when sending frames to an initiatorFC-AL options supported Fibre Channel Arbitrated Loop optionsDual port support Option SupportedSupported commands Command code Command name Supported commands Command code Supported Command nameRead descriptor mode Cheetah 10K.6 FC Product Manual, Rev. B Cheetah 10K.6 FC inquiry data Mode Sense dataCheetah 10K.6 FC Product Manual, Rev. B Inquiry data Bytes Data hexCheetah 10K.6 FC Product Manual, Rev. B DEF DEF CHG Cheetah 10K.6 FC Product Manual, Rev. B Supported Feature or condition Miscellaneous operating features and conditionsMiscellaneous features Miscellaneous statusPhysical characteristics Physical descriptionConnector requirements Part description Positions Part number FeaturesFC-SCA pin descriptions Pin Signal name Signal typePin descriptions FC-AL transmitters and receivers PowerFault LED Out Active LED Out11 SEL6 through SEL0 ID lines Enable port bypass signalsMotor start controls Parallel Enclosure Services Interface ESI Arbitrated loop physical address Alpa values SettingSetting Hex Dec LED driver signals Signal characteristicsTTL input characteristics Device control codesTransmit eye diagram Differential Pecl inputEye diagram data values Link rate GHzPresales Support Seagate Technology support services Online ServicesAutomated Services Technical SupportEuropean Support Services Customer Service CSOUSA/Canada/Latin America Support Services Call Center Toll-free Direct dial Africa/Middle East Support ServicesAsia/Pacific Support Services Cheetah 10K.6 FC Product Manual, Rev. B Index FC-AL Cheetah 10K.6 FC Product Manual, Rev. B Plogi Cheetah 10K.6 FC Product Manual, Rev. B Cheetah 10K.6 FC Product Manual, Rev. B

Related manuals

Manual 2 pages 5.2 Kb