Sekonic L-758DR manual Cord multiple flash cumulative mode

Page 30

5. Measurement

2-3 Cord multiple flash (cumulative) mode

These measurements are used when the light generated by the flash is inadequate for proper exposure. The repeated flash pops can be accumulated until the desired aperture is displayed. The cumulative number is infinite. Only one digit is displayed if the cumulative number is ten or more. Display returns 0 (0=10, 1=11, 2=12, etc.)

To activate Multiple cumulative mode, please set custom setting no.6 and Item no.1.

1.Hold down the Mode button and turn the Jog

wheel to select cord multiple flash (cumulative)

mode .

2.Turn the Jog wheel to set shutter speed. When setting shutter speed, first check the settings to confirm that they correspond to the settings available on the camera.

3.Connect the Flash synchro cord to the meter's

synchro terminal .

4.Press the Measuring button to trigger a flash. The measured f stop value at that time will be displayed. Each time this is repeated, the accumulated f stop value and the number of cumulative flashes is displayed.

Percentage of flash in total exposure

1/10 f stop

Number of cumulative flashes

 

 

Set shutter speed

Measured f stop

 

 

 

 

 

Measured f stop

 

 

(total exposure)

1st. time

2nd. time

 

3rd. time

5.To clear the cumulative value, press M. CLEAR button @3or switch to another mode by turning the Jog wheel while pressing the Mode button.

-24-

Image 30
Contents Digitalmaster Blank Safety Precautions Table of Contents Optional Accessories Technical Data Care and Maintenance FCC & IC compliance information 758DR Parts DesignationLight Meter Parts 758D/L-758CINESupplied Accessories Page Page Explanation of the Liquid Crystal Display Explanation of the Liquid Crystal Display Checking battery capacity Before UsingInserting the battery Attach the strapAuto Power Off function Setting ISO 1 sensitivitySetting ISO 2 sensitivity Jog Wheel Lock or Lock Off Incident Basic Operation Incident or reflected spot measuringSetting measuring mode LUX, FCIncident Measurement Mode Reflected Measurement Mode spot metering Shutter Speed Priority mode MeasurementMeasuring ambient light Measurement Aperture Priority mode EV mode Cinematography Measurement. Release the Measuring button to Cord Flash mode Measuring electronic flashAuto-reset cordless flash mode Percentage Cord multiple flash cumulative mode Cordless multiple flash cumulative mode Measurement Flash analyzing function Wireless Flash Radio Triggering Abcd RT-32FCC Advanced Functions Memory functionAveraging function Contrast functionMemory button Indicator of reading Set shutter speed 160000 230000 EV value → Foot-lambert FL conversion table How to use the Exposure compensation function How to use Calibration compensation function Filter compensation Filter factor number compensation 2 L-758CINE only Filters, LCD Display and Corrected ValueCustom setting function Custom setting no Calibration testing for exposure profiling Camera Exposure ProfilingCamera Exposure Profiling Input test target data Sekonic Application SoftwareOutline of software Manual Exposure Profile Input Camera Exposure Profiling Camera Exposure Profiling Analog scale Aperture scaleEV scale Points will be displayed as fast blinking Icons 3 MID.TONE buttonCamera Exposure Profiling Camera Exposure Profiling 18% Gray Card Optional AccessoriesSynchro cord Lens Hood/Step-Up Ring 30.5mm → 40.5mmRT-32CE Technical Data FCC & IC Maintenance Notes Care and MaintainanceFCC & IC compliance information FCC IDPage Memo Memo Blank TEL +810 3-3978-2335 FAX+8103-3978-5229