Pioneer AVIC-F7010BT Installation, Before installing, Installing this navigation system

Page 21

Installation

! GPS antenna and its lead

! Install the navigation unit horizontally on a

In addition you should lay or route each anten-

surface within 0 degrees to 30 degrees tol-

na lead as far as possible from other antenna

erance (within 10 degrees to the left or

leads. Do not bind them together, lay or route

right). Improper installation of the unit with

them together, or cross them. Such electro-

the surface tilted more than these toler-

magnetic noise will increase the potential for

ances increases the potential for errors in

errors in the location display.

the location display, and might otherwise

 

cause reduced display performance.

Section

04

English

Before installing

!Consult with your nearest dealer if installa- tion requires the drilling of holes or other modifications of the vehicle.

!Before making a final installation of this product, temporarily connect the wiring to

confirm that the connections are correct and the system works properly.

Installing this navigation system

Installation notes

!Do not install this navigation system in places where it may become subject to high temperatures or humidity, such as:

Places close to a heater, vent or air con- ditioner.

Places exposed to direct sunlight, such as on top of the dashboard.

Places that may be splashed by rain, for example close to the door.

!Install this navigation system in an area strong enough to bear its weight. Choose a position where this navigation system can be firmly installed, and install it securely. If this navigation system is not securely in- stalled, the current location of the vehicle cannot be displayed correctly.

!The cords must not cover up the area shown in the figure below. This is neces- sary to allow the amps and navigation me- chanism to dissipate heat.

Do not cover this area.

!The semiconductor laser will be damaged if it overheats, so don’t install the naviga- tion unit anywhere hot —for instance, near a heater outlet.

En 21

Image 21
Contents AVIC-F900BT AVIC-F700BT AVIC-F7010BT Contents Information About Your NEW Navigation System and this Manual Important Safeguards Section To prevent damage Connecting the System Before installing this productParts supplied Connecting the SystemWired Remote Input Connecting the System Connecting the systemDigital OUT Connecting the System Connecting the power cord Blue Yellow/BlackLight green Pink CAR Speed Signal InputViolet/white Reversegear Signal Input Blue/white RCA cables sold separately Screen image may appear reversed Connecting the System When connecting a rear view cameraWhen connecting Connecting the System When connecting the rear displayUsing AV1 Input AV1 When using a rear display connected to rear video outputCD-RM10 Using AV2 Input AV2Navigation unit Blue RCA connector 20 cm 7-7/8 To guard against electromagnetic interference Installation Precautions before installationBefore installing InstallationInstalling this navigation system Installation notesParts supplied Installation Installing the GPS antenna Installation When routing the lead in from the top of the door When installing the antenna outside the vehicle on the bodyMounting on the sun visor Installation Installing the microphoneAdjusting the microphone angle Installation on the steering columnAfter Installation After Installing this Navigation System Importantes Mesures DE Securite SommaireInformation Importante Avertissement 32 Fr Branchement du système Avant de raccorder ce produit Pour éviter toute détériorationRemarque concernant le câble bleu Branchement du système Pièces fourniesRemarque concernant le câble bleu/blanc Français Consultez le manuel d’utilisation pour Avertissment Branchement du système Branchement du cordon d’alimentation Bleu Vert clair Entrée rose CAR Speed Signal InputViolet/blanc Reversegear Signal Input Bleu/blanc Amplificateur de puissance vendu séparément Remarques Branchement du système Connexion de l’écran arrière Branchement d’un appareil vidéo externeUtilisation de Entrée AV1 AV1 Utilisation de Entrée AV2 AV2 IP-BUS Installation Précautions à prendre avant l’installation Avant de procéder à l’installation Installation de ce système de navigationRemarques sur l’installation Pièces fournies Installation Installation de l’antenne GPS Remarque Cheminement du câble sur le haut de la portière Installation sur le pare-soleil Installation Installation du microphoneRéglage de l’angle du microphone Installation sur la colonne de direction56 Fr Pioneer Corporation
Related manuals
Manual 2 pages 45.57 Kb