Pioneer AVIC-F7010BT Connecting the System Before installing this product, To prevent damage

Page 6

Section

03Connecting the System

Before installing this product

!This product is for vehicles with a 12-volt battery and negative grounding. Check the battery voltage of your vehicle before instal- lation.

!To avoid shorts in the electrical system, be sure to disconnect the (–) battery cable be- fore beginning installation.

To prevent damage

WARNING

!When replacing the fuse, be sure to only use a fuse of the rating prescribed on the fuse holder.

!When disconnecting a connector, pull the connector itself. Do not pull the lead, as you may pull it out of the connector.

!This product cannot be installed in a vehi- cle without ACC (accessory) position on the ignition switch.

 

CC

 

 

 

 

F

A

O

 

F

O

 

N

N

F

 

 

 

F

 

O

 

 

S

O

S

 

 

 

 

 

 

 

T

 

T

 

 

 

A

 

A

 

 

T

R

 

T

ACC position

No ACC position

!To avoid short-circuiting, cover the discon- nected lead with insulating tape. It is espe- cially important to insulate all unused speaker leads, which if left uncovered may cause a short circuit.

!Attach the connectors of the same color to the corresponding colored port, i.e., blue connector to the blue port, black to black, etc.

!Refer to the owner’s manual for details on connecting the power amp and other units, then make connections accordingly.

!Since a unique BPTL circuit is employed, do not directly ground the * side of the speaker lead or connect the * sides of the speaker leads together. Be sure to connect the * side of the speaker lead to the * side of the speaker lead on this navigation system.

!If the RCA pin jack on this product will not be used, do not remove the caps attached to the end of the connector.

!Never connect speakers with an output rat- ing of less than 50 W channel or impe- dance outside of the 4 ohms to 8 ohms specifications to your navigation system. Connecting speakers with output and/or impedance values other than those noted here may result in the speakers catching fire, emitting smoke, or becoming da- maged.

Notice for the blue lead

!A signal is output through the blue lead to control the antenna of your vehicle. The timing varies depending on the setting. (For more detailed information on changing [Ant CTRL] mode, refer to “Operation Man- ual”.)

!When [Ant CTRL] mode is set to [Radio], the vehicle’s antenna can be stowed or turned off by following the instructions below.

6

En

Image 6
Contents AVIC-F900BT AVIC-F700BT AVIC-F7010BT Contents Information About Your NEW Navigation System and this Manual Important Safeguards Section Connecting the System Before installing this product To prevent damageConnecting the System Parts suppliedConnecting the System Connecting the system Wired Remote InputDigital OUT Connecting the System Connecting the power cord Yellow/Black BluePink CAR Speed Signal Input Light greenViolet/white Reversegear Signal Input Blue/white RCA cables sold separately Connecting the System When connecting a rear view camera Screen image may appear reversedUsing AV1 Input AV1 Connecting the System When connecting the rear displayWhen connecting When using a rear display connected to rear video outputUsing AV2 Input AV2 CD-RM10Navigation unit Blue RCA connector 20 cm 7-7/8 Installation Precautions before installation To guard against electromagnetic interferenceInstalling this navigation system InstallationBefore installing Installation notesParts supplied Installation Installing the GPS antenna Installation When installing the antenna outside the vehicle on the body When routing the lead in from the top of the doorInstallation Installing the microphone Mounting on the sun visorInstallation on the steering column Adjusting the microphone angleAfter Installation After Installing this Navigation System Sommaire Importantes Mesures DE SecuriteInformation Importante Avertissement 32 Fr Branchement du système Avant de raccorder ce produit Pour éviter toute détériorationRemarque concernant le câble bleu Branchement du système Pièces fourniesRemarque concernant le câble bleu/blanc Français Consultez le manuel d’utilisation pour Avertissment Branchement du système Branchement du cordon d’alimentation Bleu Entrée rose CAR Speed Signal Input Vert clairViolet/blanc Reversegear Signal Input Bleu/blanc Amplificateur de puissance vendu séparément Remarques Branchement du système Connexion de l’écran arrière Branchement d’un appareil vidéo externeUtilisation de Entrée AV1 AV1 Utilisation de Entrée AV2 AV2 IP-BUS Installation Précautions à prendre avant l’installation Avant de procéder à l’installation Installation de ce système de navigationRemarques sur l’installation Pièces fournies Installation Installation de l’antenne GPS Remarque Cheminement du câble sur le haut de la portière Installation Installation du microphone Installation sur le pare-soleilInstallation sur la colonne de direction Réglage de l’angle du microphone56 Fr Pioneer Corporation
Related manuals
Manual 2 pages 45.57 Kb