Konica Minolta II manual Setting the Scsi ID, Ibm Pc/At

Page 10

SETTING THE SCSI ID

The Dimâge Scan Multi II’s SCSI ID is factory preset to 5. If 5 is not being used by another operating SCSI device in the SCSI chain, it is not necessary to change the SCSI ID.

A SCSI ID is a unique address you assign to each SCSI device connected to your computer. The SCSI ID range of your computer is from 0 to 7, however some IDs are already occupied by your computer.

Occupied SCSI ID

IBM PC/AT:

7 (SCSI host adapter)

Macintosh:

0 (internal hard drive)*

3 (internal CD-ROM drive)**

7(system)

*IDE Macintosh systems do not use SCSI ID 0 for the hard drive.

**Macintosh systems with a dual bus have SCSI ID 3 available on the external bus.

TURN OFF THE COMPUTER AND ALL THE SCSI DEVICES BEFORE CHANGING SCSI IDS, CONNECTING SCSI CABLES, OR DISCONNECTING SCSI CABLES.

TO CHANGE THE SCSI ID:

1.Turn off the computer and all connected SCSI devices.

2.Determine which SCSI IDs are not being used.

3.Change the SCSI ID using the upper or lower SCSI buttons.

Press the upper button to select a smaller SCSI number.

The current SCSI ID number.

Press the lower button to select a higher SCSI number.

8

Image 10
Contents Hardware Manual USA For Proper and Safe USE Table of Contents Indicator Lamp Technical Details Customer Service Package Contents Before YOU BeginSystem Requirements MacintoshNames of Parts FrontBack Setting the Scsi ID IBM PC/ATConnecting to the Computer Connecting to the Computer Plug the other end of Scsi cable a into Scsi device Plug the power cord into the scanner’s AC socket Plug the other end of the power cord into a grounded outlet Film Emulsion Getting StartedHandling Care Loading 35MM Film Holders Slide Mount Holder SH-M135MM Film Holder FH-M1 Press the cover firmly closed until it clicks Loading the Medium Format Holder MH-M1 Using the Medium Format Holder MH-M1Medium Format and TEM Film Place the film in the film holder 16mm and APS Sleeve Film Place the film in the mask using the film guides Rotating the Frame Inserting the Holder Into the Scanner EjectingAPS Adapter AD-100 Sold Separately APS Adapter Names of PartsLoading the Cassette Inserting the Adapter Ejecting the Adapter Remove the adapterChanging the Fluorescent Lamp Connect the new lamp Important Before Transporting the Scanner Troubleshooting Symptom Cause/Action ReferenceSettings Control Panel Display Indicator Lamp Indicator Lamp Scanner StatusTechnical Details APSCustomer Service To determine the version number of your driver softwareFIN
Related manuals
Manual 7 pages 3.84 Kb