Settings Control Panel Display | Konica Minolta II guide

Symptom	Cause/Action	Reference

The indicator lamp is red and blinks rapidly	1. Turn off the computer, then the scanner.	Page 28.
or	Check that the fluorescent lamp cover is
The scanned image is black.	closed.
	2. Turn on the scanner. If the fluorescent
	lamp does not glow, replace the lamp.
	3. If the cover was closed, the fluorescent
	lamp works, and the red lamp continues
	to blink rapidly, there is a hardware
	problem. Turn off and unplug the scanner,
	then call a Minolta Service Facility.


The scanned image colour is strange.	Check that there is no dust on the film or film
	holder.
	Check that the colour palette (START –
	SETTINGS – CONTROL PANEL – DISPLAY
	– SETTINGS) is on High Colour (16 bit) or
	higher. Different or additional steps may be
	necessary depending on your graphics board.
	Refer to your graphics board‘s documentation.
	If using the Medium-format holder, be sure to
	use a proper fitting mask. If the holder is dirty,
	clean it as directed.
	Reinitialize the scanner.
	Windows 95/NT: Press Control, Shift, and i
	keys simultaneously.
	Macintosh: Press Command, Shift, and i keys
	simultaneously.

Reinitializing while using the APS adapter:

1.Press the initialization key combination.

2.The adapter will eject automatically.

3.Initialization (set-up) will stop.

4.Remove the adapter.

5.Close the accessory panel.

•Initialization (set-up) will resume.

SETTINGS – CONTROL PANEL – DISPLAY