ABC Office manual Set FPD Control Registers, Host Wakeup, 28.3 DC-2/MC-1 Response

Lexicon, Inc.
DC-2/MC-1 Serial Communications Protocol	Printed on: 10/19/00

The InputId must be a valid Input Id. If it is not the DC-2/MC-1 will respond with a NAK packet and error code DC_ERR_ INVALID_INPUT_ID. If the InputName string exceeds the INPUT_NAME _LENGTH, the DC-2/MC-1 will ignore the command and transmit a DC_NAK command with an error code DC_ERR_INVALID_DATA.

7.3.28 Set FPD Control Registers

Sets FPD Control Registers to the transmitted values.

7.3.28.1 Command Packet Description

Application Header:
Command	DC_SET_FPD_CONTROL	0x2A
Data Count	4	0x04
Application	Data:
Data[0]	FPD_CtrlReg0	nn
Data[1]	FPD_CtrlReg1	nn
Data[2]	FPD_CtrlReg2	nn
Data[4]	FPD_MinUpdate	nn

7.3.28.2 Data Description

FPD_CtrlReg0: BitPack as defined in Appendix F FPD Control Registers

FPD_CtrlReg1: BitPack as defined in Appendix F FPD Control Registers

FPD_CtrlReg2: BitPack as defined in Appendix F FPD Control Registers

FPD_MinUpdate:	This value sets the minimum time between FPD Notification Transmissions.
	Data Type:	Unsigned 8 bit integer
	Default:	50(100 mSec)
	Range:	50 - 255 counts
	Conversion:	500 counts/sec

7.3.28.3 DC-2/MC-1 Response

The control register values transmitted will be copied over to the registers stored in nonvolatile RAM. The FPD_MinUpdate will be range limited. The DC-2/MC-1 will respond with an ACK Packet.

7.3.29 Host Wakeup

By transmitting the Wakeup Notification, the Host indicates it has just “powered on” or reset and is ready to receive DC-2/MC-1 Notifications or Responses. If no acknowledgment is received within ACK_TIMEOUT, the Host should indicate that the DC-2/MC-1 was not found.

7.3.29.1 Command Packet Description

Application Header:

Command	HOST_WAKEUP	0x11
Data Count	0	0x00
Application Data:
	N/A

7.3.29.2 Data Description

N/A

7.3.29.3 DC-2/MC-1 Response

The DC-2/MC-1 will respond to this command with an ACK.

30 of 44