ABC Office DC-2, MC-1 manual Host Response, Supported System Parameters

The DC-2/MC-1 includes 8 custom characters that are defined to display increments of a display block. (i.e. Volume Bar) The custom characters are ASCII character codes 08 - 0F(hex). The codes are used as follows:

'08' - left 1 bar '09' - left 2 bars '0A' - left 3 bars '0B' - left 4 bars '0C' - Full Cell '0D' - Underscore '0E' - right 3 bars '0F' - not in use

7.1.3.3 HOST Response

The DC-2/MC-1 does not look for any response from the HOST.

7.1.4 Parameter Change Notification

DC-2/MC-1 will transmit predetermined parameter change notifications. If a parameter value is changed due to any user action or system action the DC-2/MC-1 will transmit the current value of the parameter that is changing.

7.1.4.2 Data Description

0x04

0x02

nn

nn

7.1.4.1 Notification Packet Description

Application Header:

Command DC_PARAM_CHG_MSG

Data Count 2

Application Data:

Data[0] ParamId

Data[1] Value

Lexicon, Inc.

DC-2/MC-1 Serial Communications Protocol

Printed on: 10/19/00

ParamId:
	DataType:	Unsigned 8 bit integer
	Max:	Set by the System Parameter Count in the “Unit Configuration Packet”.
Value:	The Current Value for this system parameter.
	Data Type:	Unsigned 8 bit integer
	Max:	Set by the Max Value per the System Parameter Definition response

Packet for the Parameter Id of this packet.

7.1.4.3 HOST Response

The DC-2/MC-1 does not look for any response from the HOST.

7.1.4.4 Supported System Parameters

The following parameters will be supported by this Parameter Change Notification:

Parameter	DC-2/MC-1 Parameter Name
Current Effect	PROGRAM
Mute	MUTE
System Volume	VOLUME
Balance	LR_BALANCE
Input Selection	INPUT
Record/Zone 2 On/Off	RECORD_ENABLED
Zone 2 Volume	Z2_VOL

9 of 44