6. CONNECTIONS
Power cable
Connects to the power supply. (24V AC 50/60 Hz)
Alarm input/output terminal (No. 1 - 5)
Connects to the sensor of
Camera control terminal (No. 6 - 8)
Connects to cables from the Remote Controller or other camera when controlling the camera using the
| Wire color | Dot color | Terminal name |
1 | Orange | Black | GND |
2 | Orange | Red | Alarm input 3 (AL3) |
3 | Yellow | Black | Alarm input 2 (AL2) |
4 | Yellow | Red | Alarm input 1 (AL1) |
5 | Green | Black | Auxiliary output (AUX) |
6 | Green | Red | GND |
7 | Gray | Black | RS485 |
8 | Gray | Red | RS485 (+) |
Video output cable
When controlling with use of the
connect this output cable to the video input terminal of the
Note: The length of power cable, video output cable and multi wick cable is about 1.8 m.
6.1. Precautions When Installing the Camera
•Insulate the joint of the camera video output cable and the coaxial cable from other equipment by wrapping the (vinyl) insulating tape around it. Also, install such cables taking care that they do not contact metal stuff close to them.
Insulate with vinyl tape.
System controller,
Multi switcher, Monitor
•Avoid install the camera cable in close proximity to other cables of electric products, such as fluorescent lamps. Failure to do this could downgrade the picture quality.
•Installing the camera near the strong electric or magnetic field produced by television transmitting antennas, motors or transformers could distort or shake the monitor screen. In such cases, install the cables in the sheet steel cable piping.
•Before applying the power to the camera, be sure to complete all connections between the camera and related equipment.
10