TOA Electronics C-CC714 NT installation manual Hang

Page 25

9. Rotate the camera unit until it locks into place.

10. Tighten 2 camera unit mounting screws to attach the camera unit to the base unit.

Camera unit mounting screw

Camera unit mounting screw

11.Attach the dome cover.

Slide down the dome cover’s screw head through the housing suspension fitting’s slot.

Hang

25

Image 25
Contents Installation Manual Table of Contents Safety Symbol and Message Conventions Safety PrecautionsWhen Installing the Unit When the Unit is in Use General Description FeaturesHandling Precautions Modifications Nomenclature Housing Bottom Camera Unit TopCOM LED Connections Precautions When Installing the CameraCamera Control Connector Connection RS-485 Camera SettingsAbout Alarm Input About AUX OutputCamera Address Setting Switch DIP Switch 1 No Dip Switch SettingsOSD Switch DIP switch 2 No Communication Speed Setting Switch DIP switch 2 NoCommunication Method Selector Switch DIP switch 2 No Termination Switch DIP switch 2 NoCamera address setting switch 1 Camera address setting switch 65 Camera address setting switch 129 Camera address setting switch 193 About Installation InstallationInstallation Method Wall Mounting Bracket Installation Attaching Housing and Camera Unit to Wall Mounting Bracket Figure viewed from the top Hexagon socket screw M4 x 8 supplied with Mark Duct Page Hang Hexagon head Pole Mounting Bracket Installation Suspension Bracket Installation RS-485 Communications line control System ExamplesATW/ AWB SpecificationsATW/ AWB Optional Products Accessories