TOA Electronics C-CC714 NT installation manual

Page 24

Note

Do not allow the safety wire to protrude from the compartment of the camera unit. Damage may be caused to the wire if it protrudes.

Safety wire protrudes from the compartment.

Safety wire does not protrude from the compartment.

Note

When mounting the camera unit to the housing, mount it straight till it is attached to the housing correctly. Mounting it at an angle may cause damage to the camera unit.

Cross sectional view

of the housing

Cross sectional view of the housing

Camera unit

Camera unit

Mount straight

24

Image 24
Contents Installation Manual Table of Contents Safety Precautions Safety Symbol and Message ConventionsWhen Installing the Unit When the Unit is in Use Features General DescriptionHandling Precautions Modifications Housing Bottom Camera Unit Top NomenclatureCOM LED Precautions When Installing the Camera ConnectionsCamera Settings Camera Control Connector Connection RS-485About Alarm Input About AUX OutputDip Switch Settings Camera Address Setting Switch DIP Switch 1 NoCommunication Speed Setting Switch DIP switch 2 No OSD Switch DIP switch 2 NoCommunication Method Selector Switch DIP switch 2 No Termination Switch DIP switch 2 NoCamera address setting switch 1 Camera address setting switch 65 Camera address setting switch 129 Camera address setting switch 193 Installation About InstallationInstallation Method Wall Mounting Bracket Installation Attaching Housing and Camera Unit to Wall Mounting Bracket Figure viewed from the top Hexagon socket screw M4 x 8 supplied with Mark Duct Page Hang Hexagon head Pole Mounting Bracket Installation Suspension Bracket Installation System Examples RS-485 Communications line controlSpecifications ATW/ AWBATW/ AWB Accessories Optional Products