TOA Electronics C-CC714 NT installation manual Wall Mounting Bracket Installation

Page 19

8.3. Wall Mounting Bracket Installation

Use the optional C-BC711W Wall Mounting Bracket.

Notes

Check to be sure that wall surface can structurally support the weight of the camera and mounting bracket

Bolts, nuts and washers are not supplied with the bracket. Use bolts, nuts and washers that are appropriate for the wall's structure and composition.

Be sure to hang the safety wire first when installing the unit.

1. Make a cable entry hole of ø 50 – 100mm on a wall.

C-BC711W (optional)

Wall surface

ø50 – 100 mm

2.Run the cables to be connected to the camera through the wall mounting bracket, then fix the bracket on a wall.

Nut

Spring washer

Plain Washer

Cable entry hole

Anchor bolt (M8, M10 or W3/8)

19

Image 19
Contents Installation Manual Table of Contents Safety Symbol and Message Conventions Safety PrecautionsWhen Installing the Unit When the Unit is in Use General Description FeaturesHandling Precautions Modifications Nomenclature Housing Bottom Camera Unit TopCOM LED Connections Precautions When Installing the CameraAbout AUX Output Camera SettingsCamera Control Connector Connection RS-485 About Alarm InputCamera Address Setting Switch DIP Switch 1 No Dip Switch SettingsTermination Switch DIP switch 2 No Communication Speed Setting Switch DIP switch 2 NoOSD Switch DIP switch 2 No Communication Method Selector Switch DIP switch 2 NoCamera address setting switch 1 Camera address setting switch 65 Camera address setting switch 129 Camera address setting switch 193 About Installation InstallationInstallation Method Wall Mounting Bracket Installation Attaching Housing and Camera Unit to Wall Mounting Bracket Figure viewed from the top Hexagon socket screw M4 x 8 supplied with Mark Duct Page Hang Hexagon head Pole Mounting Bracket Installation Suspension Bracket Installation RS-485 Communications line control System ExamplesATW/ AWB SpecificationsATW/ AWB Optional Products Accessories