TOA Electronics C-CC714 NT installation manual Suspension Bracket Installation

Page 28

8.6. Suspension Bracket Installation

The C-BC711P Suspension Bracket is required to suspend the camera from a ceiling.

Note

Mount the bracket to a concrete wall or robustly constructed wall surface that can sufficiently withstand the weight of the units.

1. Make a cable entry hole of ø 50 – 100mm on a ceiling.

Hole diameter: ø 50 – 100mm

C-BC711P (optional)

2. Attach the suspension bracket to a ceiling.

Note: Bolts, etc. are not supplied with the bracket.

Ceiling surface

Anchor bolt

M8, M10 or W 3/8

Plain washer

Spring washer

Nut

3.For installation procedures of the housing, camera unit and the dome cover, refer to p.20 as the procedures are the same as that of wall mounting.

28

Image 28

Contents Installation Manual Table of Contents Safety Symbol and Message Conventions Safety PrecautionsWhen Installing the Unit When the Unit is in Use Features General DescriptionHandling Precautions Modifications Housing Bottom Camera Unit Top NomenclatureCOM LED Precautions When Installing the Camera ConnectionsCamera Settings Camera Control Connector Connection RS-485About Alarm Input About AUX OutputDip Switch Settings Camera Address Setting Switch DIP Switch 1 NoCommunication Speed Setting Switch DIP switch 2 No OSD Switch DIP switch 2 NoCommunication Method Selector Switch DIP switch 2 No Termination Switch DIP switch 2 NoCamera address setting switch 1 Camera address setting switch 65 Camera address setting switch 129 Camera address setting switch 193 About Installation InstallationInstallation Method Wall Mounting Bracket Installation Attaching Housing and Camera Unit to Wall Mounting Bracket Figure viewed from the top Hexagon socket screw M4 x 8 supplied with Mark Duct Page Hang Hexagon head Pole Mounting Bracket Installation Suspension Bracket Installation System Examples RS-485 Communications line controlSpecifications ATW/ AWBATW/ AWB Accessories Optional Products