TOA Electronics C-CC714 NT installation manual Hexagon head

Page 26

12. Align the dome cover’s 4 screws with the hexagon head sleeves inside the housing.

Note

Be sure to attach the dome cover after sliding down its screw head through the housing suspension fitting’s slot so that the dome cover can be attached securely to the housing.

Hexagon head

Hexagon head

sleeve

sleeve

Rib

Rib

Dome cover

13.Tighten 4 screws equally to attach the dome cover to the housing and ensure that the dome cover does not rattle.

26

Image 26
Contents Installation Manual Table of Contents When Installing the Unit Safety PrecautionsSafety Symbol and Message Conventions When the Unit is in Use Features General DescriptionHandling Precautions Modifications Housing Bottom Camera Unit Top NomenclatureCOM LED Precautions When Installing the Camera ConnectionsAbout Alarm Input Camera SettingsCamera Control Connector Connection RS-485 About AUX OutputDip Switch Settings Camera Address Setting Switch DIP Switch 1 NoCommunication Method Selector Switch DIP switch 2 No Communication Speed Setting Switch DIP switch 2 NoOSD Switch DIP switch 2 No Termination Switch DIP switch 2 NoCamera address setting switch 1 Camera address setting switch 65 Camera address setting switch 129 Camera address setting switch 193 Installation Method InstallationAbout Installation Wall Mounting Bracket Installation Attaching Housing and Camera Unit to Wall Mounting Bracket Figure viewed from the top Hexagon socket screw M4 x 8 supplied with Mark Duct Page Hang Hexagon head Pole Mounting Bracket Installation Suspension Bracket Installation System Examples RS-485 Communications line controlSpecifications ATW/ AWBATW/ AWB Accessories Optional Products